Corradi PERGOTENDA 100 INCLINADO Manual Del Usuario página 48

LIMIT STOP ADJUSTMENT SLOPE 95 AND PLUS 96 MOTORS
Proceed with maximum caution in accordance with the safety
regulations in force.
- Check that the motor is correctly connected to the exchange and that
the exchange is correctly connected to the mains.
If not present make the connections as indicated in the wiring scheme.
- Push the START button (1) on the remote computing system
exchange and wait for the led to turn RED (2), and then release the
switch.
The awning starts to descend; once it gets to the limit switch it will stop
for approximately 1 second and then it will move upwards
automatically.
- Push the STOP button (3) as soon as you reach the point where you
would like to have the limit switch on the upper side.
It is then possible to use the remote control supplied.
Then proceed with assembly of the awning. The tension of the canvas
when opening is managed by the exchange, whilst the point at which
the stacked awning stops is the point memorised with the STOP
button.
If the motor stops (because of overheating), the red LED (2) flashes: after
approximately 5 minutes the light goes off and the motor can be used
again.
Tuning a new remote control
Press the MEMO button (4), the LED (5) flashes twice, keep the MEMO
button (4) pushed down and press the remote control button at the
same time, the LED (5) flashes twice indicating that the remote control
has been recognised.
Cancelling remote control memory:
You can cancel all the remote control codes by pressing the CANC
button (6) and waiting for the LED (5) to stay permanently red.
3 - 04.2011
5 6
4 3
Motore SLOPE 95
230 V/50 Hz
M1
In= 0,97 A
Pn= 218 W
IP= 54
Fu 250V/200mA
Push-button panel maintained,
supplied and installed by an electrician.
Positioned within the awning's
operating field
CORRADI S.P.A. - USER MANUAL - PERGOTENDA 100
ADJUSTING THE COMMANDS
ELECTRIC DRIVE TYPE 3 (SLOPE 95 AND PLUS 96 MOTORS)
With automatic opening limit switch for two motors including a remote control.
2 1
1
2
3
3 1
2
TANDEM 00757 Exchange
M2
PLUSE 96 Motor
230 V/50 Hz
In= 0,97 A
Pn= 218 W
IP= 54
47 of 119