Klarstein SAINT HELENS STUDIO LOFT 2 Manual De Instrucciones página 66

EN
66
Problem
No warm air is blowing
out.
The logs are glowing but
there is no flame effect.
The flame effect is working
but the heating function
is not working, the ember
bed lights up when the
heating button is pressed.
The heating function is not
working.
Possible cause
Cooling cycle
The thermostat setting
prevents the heating
function from being
activated.
The flame effect is
deactivated.
The heating function is
deactivated
The safety switch has been
activated.
Solution
Normal operation
continues for a few
minutes before switching
off. The time depends on
the current temperature.
During this time, cold air is
blown out.
Adjust the temperature
setting so that the
thermostat is set higher
than the current room
temperature.
Press the flame button
several times.
With the unit switched
on, press and hold the
On/Off button for 10
seconds. As soon as
the heating function has
been activated again,
the ember bed lights up
several times.
Turn off the power switch,
wait 15 minutes and turn it
on again.
Check the fuse. If this is
broken, the fuse must be
replaced.