Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Do not stand on one of the upper
3 rungs of a leaning ladder!
Do not stand on one of the upper
2 rungs of a standing ladder.
Warning! Do not insert your fingers
into the holes in the ladder frame.
Do not stand on the top rung!
Ensure that the top end of the ladder
is properly supported!
Before use
Q
J
A void damage when transporting ladders on
roof racks or in a lorry. Make sure that the
ladder
is appropriately fastened in place.
1
J
B efore using the ladder
Check that all parts are undamaged and in
good working order.
J
R emove all contamination on the ladder
such as wet paint, dirt, oil or snow.
J
L ock all doors and windows (but not emergency
exits) in the area around the ladder
you are going to work.
How to use
Q
CAUTION! RISK OF CRUSHING! Take
particular care when opening or closing the
ladder
. Keep your distance from moving
1
parts and the safety devices.
Attaching the stabilisers
Q
ATTENTION! Never use the ladder
out the stabilisers attached
J
U se the supplied stabilisers
J
I nsert the stabilisers
ends of the ladder
1
, visually inspect it.
1
,
1
where
1
with-
1
.
2
only.
2
into the slots
at the
2
9
(see Fig. D). Ensure that the
Safety instructions / Before use / How to use
holes
in the stabiliser and the ladder end
8
align with one another.
J
G uide four bolts
and secure the connection with one plain
8
washers
and nut on each bolt
4
ATTENTION! Check every time before load-
ing the ladder
rectly attached.
Operating the hinge system
Q
J
B efore each use, check that all the hinges
are properly engaged. The hinges
parallel to one another must always be engaged
at the same setting.
J
U nlock the hinges
lever
backwards (see Fig. E).
11
J
A rticulate the desired section of the ladder at the
hinges
. The hinges engage automatically in
10
the next position. Unlock the hinges
if you would like to articulate the ladder further.
ATTENTION! The hinges
audible click. However, you should always check
that the safety indicator
(see Fig. G). Do not load the ladder if the safety
indicator
12
Using the working platforms
Q
J
D o not use the ladder without a working platform
,
when you are carrying out an activity
6
7
that requires a working platform
Fig. B). Do not use a working platform
for ladder positions that are not designed to have
working platforms fitted (see Fig. A, C). Failure
to observe this advice when using the product
can lead to severe injury and / or damage to
the product.
J
U se the supplied working platforms
J
U se the working platforms
antislip profile
J
H ook the lip
forms
,
6
7
section and check that the other end of the
working platform
in a similar manner. The safety hooks
(included) through the holes
3
(see Fig. D).
5
that the stabilisers
1
2
10
by pulling the unlocking
10
10
engage with an
10
shows "engaged"
12
shows "unlocked" (see Fig. F).
,
6
6
,
only with the
6
7
facing upwards (see Fig. I).
15
on the end of the working plat-
13
over the last rung of the ladder
,
also rests on a rung
6
7
are cor-
10
lying
again
(see
7
,
6
7
,
only.
7
prevent
14
GB/MT
25
Tabla de contenido
