Balcrank 3331-031 Guía De Servicio Técnico Y Recambio página 4

EN EN
OPERATION
NOTE: By default and for your safety, dispensing is disabled,
you must activate the AUTO mode as detailed below to be
able to dispense fluid.
NOTA: Before activating the preset mode, make sure the
trigger is not pulled.
To begin dispensing fluid follow the procedure below:
1. By means of the quantity set buttons ("10" , "1" , "0.1" buttons)
set the quantity you wish to dispense in the top row (fig. 1).
Each press of the button increases the preset quantity by
10, 1 or 0.1 units. If you press and hold one of these buttons,
the corresponding digit is reset to zero in each case.
If you do not know the amount you want to dispense and
you want to manually control the dispensing, preselect a
safely larger amount than the volume you want to dispense.
When you finish dispensing, the amount you actually
dispensed will be stored.
2. Once the quantity has been set, and making sure that
the trigger is not pressed, press the "AUTO" button. The
"AUTO" indicator lights up on the display, the partial
counter is reset to zero and the preset quantity is shown
on the bottom line (fig. 2). The gun is already prepared
to start dispensing.
3. During dispensing mode the trigger (1) may be manually
operated or you can leave the trigger fixed in open valve
position by means of the locking button (2). In both
cases, the valve will automatically closed when the
preset amount is reached.
To lock the trigger in the open position: pull the trigger,
move the locking button forward with your index finger
and, holding it in this position, let the trigger down. Once
the trigger is locked, you can stop pushing the button.
4. If you want to stop dispensing before the preset amount
is reached, press the AUTO button. The display will
show "-stop-" on the bottom line (fig 3) and the amount
dispensed up to that point is stored.
5. If dispensing is not interrupted, when the preset value is
reached the valve closes automatically and "finish" is
displayed on the bottom display line.
4
SB3115 R. 07/22
Balcrank™ Corporation · Weaverville, NC 28787 · 800-747-5300 · 800-763 0840 Fax · www.balcrank.com
6. Finally, release the trigger if it was manually operated or
press it upwards and then let it return to its rest position
if you had used the locking button.
Fig. 1
Fig. 2
1 2
Fig. 3