TFK mono 2 Instrucciones De Uso página 13

maximally applied and the brake is permanently locked. To release the
parking brake, pull the brake lever (12) and release the grey parking
lever (13). When the braking effect decreases, you can make a fine
adjustment. To do this, turn the adjustment screw on the brake handle
anti-clockwise and check the braking effect again.
Use as a combination pushchair:
Fig. 6:
The mono-tub of the combi pushchair is pushed from above over the
bolts (14) onto the frame struts until it locks into place. For everything
else, please refer to the instructions for the carrycot.
Without illustration: The group 0 adapters are placed on the same pins
(14). To remove them, you must press the grey button and pull them
upwards.
Use as a pushchair:
Fig7.:
Place the footboard on the lower crossbar of the frame and optionally
secure it in this position with the Velcro at the narrow end on the back
around the frame tubes. You can bring the footboard into a horizontal
position by tilting it. To hold it in this position, you can insert the bracket
located on the underside into the holder provided.
Fig. 8.:
The seat cover is connected to the frame with four piping straps. First
insert these from above into the openings (a) located on the height
adjustment of the push bar and repeat the step with the piping straps
below the folding joint (b).
Fig 9.:
Then guide the straps in the head area of the seat cover through the
loop on the height adjustment and fasten each with a press stud on
the backrest (c). Then close the two press studs under the seat (d) and
the two pins (e) on the footrest. In addition, the straps of the backrest
adjustment (f) must be passed through the opening in the seat cover
and around the frame tube and closed with the push buttons. Finally,