Hanging The Unit On The Wall Fixture; Make Sure The Unit Is Level - Rational iVario Pro L 60.75.993 Manual De Instalación Original

4 | Installation
a
The hook plates are ready for use.
a
The covering panel and the seal are
ready for use.
a
6 M10x40 hexagon screws are ready
for use.
a
The metal template for the unit is
ready for use.
a
A torque wrench (32 Nm) is ready for
use.
1. Drill the 3 marked holes for the hook
plates on the back of the electrical
compartment in the metal sheet. Use
the enclosed metal template.
[ Image 06.1]. Pay attention to a
maximum drilling depth of 2 mm
[2/25 inches].
2. Remove the 3 cover caps on the left
rear side of the unit [
3. Put the seal on the covering panel.
4. Hold the covering panel on the holes in
the unit and screw the hook plates
with 3 M10x40 hexagon screws each
[ Image 07].
>
The covering panel with seal and
the hook plates are attached to the
unit.
4.3 Hanging the unit on the wall
fixture
NOTICE
The alignment screw can be damaged
when mounting the unit
Pay attention to the alignment screw
when mounting the unit. If the screw is
damaged, the unit can no longer be
properly aligned.
80.51.902_iVario-iVario Pro L_XL_Wall mounting_V01_EU-west
a
a
a
a
a
1. Lift the unit under the unit base frame
2. Remove the 4 transport feet. Unscrew
3. Position the unit in front of the wall
Image 06.2].
4. Mount 1 M10x90 hexagon socket
>>

4.4 Make sure the unit is level.

a
a
a
a
1. Hold the spirit level lengthways on the
2. Align the unit with the right alignment
The wall panels are correctly mounted
on the wall.
The hook plates are correctly mounted
on the unit.
2 M10x90 hexagon socket screws are
ready for use.
A lift truck or shear trolley is ready for
use.
At least 2 people are recommended
for mounting.
using a lift truck or shear trolley.
the lower foot and remove the fasten-
ing screw of the upper foot.
[ Image 08].
panels with the lift truck or shear trol-
ley and mount it with care.
screw on the respective hook plate
through the installation hole in the
covering panel [
The unit is mounted on the wall fix-
ture.
The unit is mounted on the wall fix-
ture.
A tool with a wrench size of 17 mm is
ready for use.
A spirit level is ready for use for use.
2 people are required for alignment.
right underside of the unit
[ Image 10.1].
screw on the wall panel.
en
Image 09].
13 / 84