Schulz MIS 100 Manual De Instrucciones página 32

Inversor de soldadura mma + tig
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

for some time. Therefore, do not handle any objects near the welding place without proper protective gloves;
• Harmful gases are released during the welding process. Take care not to inhale such gases.
• People near the welding place must be informed of the danger and equipped with proper protection and safety
equipment. If necessary, use a protective screen and keep other people at least 15 meters away from the work
place, preventing them to have contact with or direct visualization of the welding arc. Warn about the danger by
means of signs, such as: "Danger! Stay away!"
• In the surroundings of the work place, the walls and screens must not have light colors or be reflective. If there
are windows, they must be covered, for instance, by proper paint;
• Do not allow the presence of children, animals or non-qualified people in the work place. If that occurs, require
the use of safety equipment; • Do not perform Jobs and/or welding near the power grid (for instance, o power
cables) or tanks in which gases, fuels, oils or similar substances are stored. Risk of explosion or shock. • In case
of using the welding equipment under hazardous conditions, for instance, in narrow rooms with conducting walls
(boiler, piping), in humid rooms (bathrooms) or hot rooms (sauna), the output voltage of the welding equipment in
operation without load cannot be over 48V (effective value). In these environments, you must use other individual
protective equipment (for eample, insulating blankets) in order to electrically insulate teh body from teh wall or
floor. Refer to the Law in force for further information about protection equipment.
About the welding process:
• Do not hit the work piece with the electrode. That may damage the materials and make the ignition of the elec-
tric arc more difficult; • Pay attention to always place the rod holder on an insulated surface after the welding;
• Remove the dross only after the cooling down of the weld. If the weld is continued after a pause, remover the
dross before continuing the process.
Workplace and Point of Use:
- Keep the place clean, tidy and illuminated.
- In order to avoid distractions and accidents, after using your tool, isolate the workplace to prevent access of
visitors, children or animals.
- Power outlet must be compatible to the tool plug. To reduce the risk of shock, do not change the plug characte-
ristics and do not use adapters. If required, replace the outlet with a plug suitable model.
32
Tabla de contenido
loading

Este manual también es adecuado para:

Mis 130Mis 140Mis 180Mis 200

Tabla de contenido