Tabla de contenido
Idiomas disponibles
Idiomas disponibles
C
Useful information
Troubleshooting
CAUTION!
Before troubleshooting, disconnect the power supply.
Only a qualified electrician of competent person must do
the troubleshooting that is not in this manual.
IMPORTANT!
There are some sounds during normal use
(compressor, refrigerant circulation).
Problem
Possible cause
Temperature regulation knob
is set at number "0".
Mains plug is not plugged in
or is loose
Appliance does not work
Fuse has blown or is defective
Socket is defective
Temperature is not properly
adjusted.
Door was open for an
extended period.
The food is too warm.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
16
Solution
Set the knob at other number
to switch on the appliance.
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to be
corrected by an electrician.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature to a
colder setting temporarily.
please look in the installation
location section.
EN
C
Useful information
Problem
Possible cause
Appliance cools too much
Temperature is set too cold.
Appliance is not level.
The appliance is touching the
wall or other objects.
Unusual noises
A component, a.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
Water on the floor
Water drain hole is blocked.
It's normal. Heat exchange
Side panels are hot.
parts are in the sides.
If the malfunction shows again, contact the Service Center.
17
Solution
T u r n t h e t e m p e r a t u r e
regulation knob to a warmer
setting temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend
the component out of the way.
See the Cleaning an Care
section.
Take gloves to touch sides.
EN
Tabla de contenido
