Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION
1 Placing rightly
Keeping proper space
Too small space around it, putting goods on the
top or side, and pasting our on the side might
prevent heat generation, resulting in unnecessary
wastage of energy.
Contacting between back and wall might cause
vibration and noise.
Heat radiated from the refrigerator might wear
our the wall or other things of space is too small.
Avoiding heat and moisture
Heat, sunlight shining directly would infulence
cooling seriously and waste the electric energy.
Many troubles are caused by moisture.
Locating firmly and horzontally
Rotate the adjustable feet one round (let the from
feet hand in the air) and then firm the refrigerator
horizontally (to avoid vibration and noise).
! Attentions
A piece of wood should be placed first if the re-
frigerator is located on the carpet etc.
2
Above 5cm
Above 5cm
Above 5cm
Earth line
! Cautions
The earth line should be connected if the refrigerator
is located at the moist place such as toilet,
laundryroom, basement etc.
Earth terminal (triangle plug)
Please connect one side of the earth line to
the earth terminal
2
3
Tear down the tape
Turn on the power
firming case
Clearing with
wet cloth
In hot season freezing foods completely needs 24 hours.
check the cooling condition in the next day .something such as
ice-cream should be frozen completely.
5
Pay more attention while moving.
Screw compressors are adopted inside. Inclination angle is no more than 45 degree.
Temperature adjustment . . . Usually in MID position
Temperature knob is to be adjusted temperature of box. The number on it can not show temperature
Big number show the temperature of box is low and little number show is high."0"show stop. In winter,
usually place the knob at 4-7,In summer usually place the knob at 4-1.
Caution:
1.Please obey the step of control;
2.Improper adjust may lead to lower temperature, higher temperature or influence energy consumption.
Changing the light bulb
If you need to replace the lamp, please according to below instruction,
1.oull out the power plug first,
2.unscrew the old lamp, replace the new lamp,
Note: the lamp power is 10W,
the bulb must be according to IEC 60079-15.
4
Storing after turning on
power 4~5 hours
Donˇ t o pen
the door
The smell of plastic will disappear
automatically a period later.
3
Tabla de contenido
