Additional Information; Regulatory Information - Aritech TX-6010-03-1 Hoja De Instalación

In case of a fire
In the event of a fire, do the following:
• Leave immediately. Don't stop to pack or search for
valuables.
•
In heavy smoke, hold your breath and stay low, crawl if
necessary. The clearest air is usually near the floor.
•
If you have to go through a closed door, carefully feel the
door and doorknob to see if undue heat is present. If they
seem cool, brace your foot against the bottom of the door
with your hip against the door and one hand against the
top edge. Open it slightly. If you feel a rush of hot air, slam
the door quickly and latch it. Unvented fire tends to build
up considerable pressure. Be sure all members of the
household realize and understand this danger.
• Use your neighbour's phone or a street fire alarm box to
call the fire department. The job of extinguishing the fire
should be left to the professionals.
Be prepared
Practice the following steps to prepare you and your family in
the event of a fire:
•
Perform fire drills regularly. Use them to assure
recognition of an alarm signal.
•
Draw a floor plan and show two exits from each room. It is
important that children be instructed carefully, because
they tend to hide in times of crisis.
•
Establish one meeting place outside the home. Insist that
everyone meet there during an alarm. This will eliminate
the tragedy of someone re-entering the house for a
missing member who is actually safe.
•
If you have children or physically challenged people
residing in your household, use window decals to help
emergency personnel identify the sleeping quarters of
these individuals
False alarms
Smoke / heat detectors are designed to minimise false alarms.
Cigarette smoke will not normally set off an alarm, unless the
smoke is blown directly into the device's sensor.
Combustion particles from cooking may set off the device if the
alarm is located close to the cooking area. Large quantities of
combustible particles are generated from spills or when
broiling.
Using the fan on a range hood which vents to the outside (non-
recirculating type) will also help remove these combustible
products from the kitchen. If the device does sound, check for
fires first. If a fire is discovered, get out and call the fire
department.
If no fire is present, check to establish may have caused the
alarm. Check the area of the device, only when certain that it is
safe to do so and check that the device's sensitivity selection is
appropriate for its environment.

Additional information

The points below must also be followed:
•
DO NOT paint the device, as this can cause contamination
of the sensor.
P/N MK256-ML • REV F • ISS 04FEB22
•
Ensure that detectors are kept accessible and that there is
clear space around all devices.
•
The operation of devices should be checked upon the
reoccupation of premises after vacation, etc.
For details on the connected alarm panel's smoke / heat alarm
capacities, refer to the alarm panel product guides for details.
This device is not suitable for installation in LAVs.
Specifications
Current consumption (nominal)
30 μA
Standby
Alarm 200 mA
Test 60 mA
Batteries 2 x 3 V Lithium Duracell DL123 batteries
Notes
- Up to four batteries can be fitted to extend
battery life
- Replace only with specified batteries
- DO NOT mix batteries of different type or
age
CAUTION!
are incorrectly replaced. Replace only with
the specified batteries and replace all
batteries at the same time
Operating voltage 2.4 to 3.3 VDC
Estimated battery life 5 to 10+ years (depending on number of
batteries fitted)
Low battery indication Audible alert every 45 seconds
Smoke sensitivity
0.09 ±0.01 dB/m
High
0.12 ±0.01 dB/m
Low
Heat sensitivity
Class A2 (rate of rise) 58°C
High
Class B (rate of rise) 72°C
Low
Drift compensation 1.64%/m (0.5%/ft.) max.
adjustment
Sounder 85 dBA at 3 m (continuous tone)
Supervisory signal Every 15-18 minutes
RF frequency
TX-6010-03-1 868 MHz
RF581I4 433 MHz
Max RF output
TX-6010-0301 14 dBm (25 mW)
RF581I4 10 dBm (10 mW)
RFI immunity Complies to EN 301 489-3,
EN 14604:2005/AC:2008, BS 5446-2:2003
Modulation type AM
Transmitter ID Preprogrammed. 1 million codes
−10 to +55°C (+14 to 131°F)
Operating temperature
0 to +30°C (+32 to 86°F)
Storage temperature
Relative humidity Up to 90% noncondensing
Dimensions (W x H) 10.9 x 6.2 cm (4.3 x 2.2 in.)

Regulatory information

This section includes both regulatory information and a
summary on the declared performance according to the
Danger of explosion if batteries
5 / 60