Temper KEH-470 Manual De Instrucciones página 13

KEH470
Hydraulic Crimping Tool
3. Function Description
1) "C" type crimping head
manually.
OPERATING INSTRUCTIONS
Read the entire SAFETY INFORMATION section at the beginning of
this manual including all text under subheadings therein before using
this product.
Please do not knock any part of the tool; otherwise it is dangerous for
operator.
1. Select the appropriate die set. Ask an authorized facility or distributor to
choose proper compression die set for the connector and cable being
used.
Don't operate the tool without dies.
2. Insert the upper crimping die and the down crimping die to match the
die holder when both die halves are in place.
2) Release the pressure
3. Make sure both dies halves are secured before operating the tool.
4. Fully insert the cable into the barrel of the connector. 5. Place the connector between the dies, Pump the handle until reach to
the maximum pressure, then spin the screw to release the pressure
manually.
6. The piston will retract, take out the connector, the tool is ready for its
next cycle.
www.grupotemper.com