Opera CAMPO Manual De Usuario página 17

EN
OPERATING INSTRUCTIONS
Exchange and cleaning of the grease-filter
Fire risk ! The performance of the extrac-
tor hood is affected by containing fat
remains and therefore the fire risk in-
creases. To prevent a fire risk please
clean the metal filter regularly. By models
with a pane beneath the filter.
By models with a pane beneath the filter ("Perimeter Extraction") the pane has to be remo-
ved at first. For this swing at first the small front glass pane with one hand upwards and
then take the filter out at its grip. The metal grease filter is fixed by a magnet. The installati-
on is made in reverse order. The metal grease filter is to be cleaned at best in a dishwasher
or in hot soapy water. Aggressive cleaners should not be used. The guarantee can´t be ap-
plied if a discolouring on the filter is a result of using an aggressive dishwashing liquid.
Please avoid temperatures over 55 degrees. Caution: Do not wash grease filter together
with silver cutlery in the dishwasher! This leads to destruction of the grease filter (galvanic
element, not a complaint claim)
Attention : do not use 3-phase-cleaners or clean the filter in a commercial dishwasher. The
use of aggressive cleaners like fuel, acetone, trichlorethylene destroys the filter!
Reinstate the metal filter after the cleaning. By models using the "Perimeter Extraction" me-
thod the pane has to be brought afterwards in its original position. Therefore please press
the pane with both hands upwards to a certain extent (lock in of the pane).
Please note : Due to a galvanic reaction that occurs during the rinsing process, the metal
grease filters must not be washed with silver cutlery or silver dishes at the same time. Un-
fortunately, there is no right to complain if this fact is not taken into account.
Put the metal filter back after cleaning. For models with edge extraction, the panel must
then be returned to its original position. To do this, guide the plate upwards with both hands
until it clicks into place.
Attention : hoods with stainless steel filters have a safety chain! This must be released
when removing the filter. When installing the filter * hang the safety chain back on the filter,
when inserting the filter make sure that the safety chain protrudes into the filter.
Exchange activated charcoal filter
C-version only, circulating air:
The activated carbon filter (7) is located in the filter support (18) behind the right exhaust
grille (21), which is held in place by magnets.
Remove the exhaust
grille and pull out the
filter.
Dispose of the used ac-
tivated charcoal filter as
regeneration is not pos-
sible.
Slide the new filter into the tower and lock it.
17