•
Dismantling lock barrel
1
Unlock lock and fold handle
upwards.
Open case/topcase.
Using the wire, press in retaining tab
draw lock barrel
e
Attention
Never withdraw key from removed lock
barrel, as the locking tabs will spring out
of lock barrel.
•
Removing pressure elements
2
Carefully drive out grooved pin
punch and remove pressure elements
•
Drilling out rivets
3
Drill into rivets
using angle power drill with twist drill ø 4 mm.
•
Removing multi-function box
4
With the case/topcase open, prise multi-function
box
out of case/topcase
driver.
Remove remainder of rivets.
e
Attention
Ensure that no rivet pieces or drill chip-
pings enter lock mechanism.
12
and locking lever
and with-
on key.
using the drift
.
(7x) until rivet heads fall off
using a screw-
•
Removing front trim
5
Using a screwdriver, prise front trim
sides from spacer studs
•
Dismantling catch
6
Drill into the two rivets
using twist drill ø 4 mm and remove drill chip-
pings.
e
Attention
Ensure that no rivet pieces or drill chip-
pings enter lock mechanism.
Remove defective catch
, washer
and housing
Remove remainder of rivets.
•
Fitting new catch
7
Push new catch
into housing
Insert washer
and compression spring
catch.
Insert complete housing into lock assembly
ensuring that lug
hole
on lock assembly.
Secure housing with the two shorter of the sup-
plied rivets
.
at the
and remove.
until rivet heads fall off
, compression spring
.
.
into
locates in corresponding
;
