Machine Information - VONROC WS503AC Traducción Del Manual Original

on. Allow to cool down for 10 minutes.
• Do not allow the hose to become kinked or
blocked by debris. In the event of a hose blockage
remove the plug from the wall socket.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate label.
Replacing cables or plugs
If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his
agent in order to avoid a safety hazard. Immedi-
ately throw away old cables or plugs when they
have been replaced by new ones. It is dangerous to
insert the plug of a loose cable in the wall outlet.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
The wall paper steamer is developed for stripping
wall paper. The steam helps removing wall paper
without chemicals. This machine converts water
into steam.
TECHNICAL SPECIFICATIONS
Model No. WS503AC
Voltage 220-240V~ 50-60Hz
Input power 1900-2300W
Protection class Class I
IP number IPX4
Boiler Capacity 4.5 L
Weight 2.18 kg
Tube length 400 cm
Tube diameter 22 mm
Steam plate dimensions:
Steam plate 100x150mm
Steam plate base 280x195mm
Working time (4.5L) 70 min
WWW.VONROC.COM
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-3.
1. Boiler carrying handle
2. Boiler tank
3. Water level indication
4. Hose
5. Hose connector
6A. Steam plate
6B. Steam plate base
7. Filler cap
8. Power cable
9. Wall scraper
3. ASSEMBLY
Fitting the hose (fig. A and B)
• Screw one end of the hose (4) to the hose con-
nector (5) on the boiler tank (2).
• Screw the other end of the hose (4) to the steam
plate (6).
• Check that the hose has been connected properly.
Initial filling of the boiler reservoir (fig. C)
Warning! Make sure that the appliance is
unplugged.
• Unscrew and remove the filler cap (7).
Note: When filling the boiler, use clean tap
water only.
• Fill the boiler tank (2) with water.
Do not overfill the tank past the MAX indicator
(maximum 4.5 litres) see fig. D.
• Place the boiler filler cap (7) back, do not over-
tighten.
• Place the steam plate (6) in a bucket before
starting the machine, never lay the steaming
plate flat on a surface always on its back see
fig. H.
Power cable (fig. E)
• Plug the connector of the power cable (8) in to
the machine.
• Plug the mains plug of the power cable (8) into
the power supply.
• The machine will automatically start working
when plugged in correctly.
TIP! Fill the machine with warm tap water to shorten
the warm-up time.
EN
5