Storage After Use; Maintenance; Troubleshooting - Jetboil FLASH Manual De Instrucciones

extinguish flame. 2. Remove pot from burner base – hold pot by cozy (10.1), and
base by shroud (10.2).
Exposed metal parts will be hot and may cause injury if touched.
3. Always disconnect fuel canister after use. Unscrew fuel canister from burner
base (Fig 4), and replace plastic fuel cap.
Always check that the burner is extinguished before disconnecting the
fuel canister. Vapors can ignite and cause serious injury.
Packing:
1. Allow stove to fully cool before packing. 2. Place bottom cover (7.1) on pot (7.2).
3. Remove stabilizer from canister and fold for storage (1.2). 4. Fold Valve bail
under valve body (1.3). 5. If using the pot support: Remove pot support from burner base
(Fig 12), and fold legs (1.4). 6. Refer to Fig 1 for packing contents into pot.

STORAGE AFTER USE

1. Always disconnect fuel canister before storing the stove. 2. Ensure stove and
pot are clean and dry before storing. 3. Store the stove in a cool, dry location,
indoors.
MAINTENANCE 1. Flame Check (Every use): The height of the flame should
increase from low to high with counter-clockwise rotation of the control valve.
Flame should be blue with no yellow tipping at full output. Flame should not flash
back into burner or lift off of burner top. If flame abnormalities are found, see
your dealer or contact Jetboil for service. 2. Cleaning Pot (before storage, or as
needed): Allow pot to cool before cleaning. Do not use a dishwasher or abrasive
compounds (sand, salt, etc.) to clean. Only wash by hand with soapy water.
TROUBLESHOOTING 1. Flame does not extinguish: Tighten valve as much as
possible, blow out flame, and immediately detach fuel source. See your dealer or
contact Jetboil for service. 2. Igniter fails to spark: If igniter will not spark, check
positioning of electrode in relation to burner. Approximately 1/8" (3mm) length of
igniter wire should protrude from the igniter ceramic. Wire should point toward
center of burner with a 1/8" (3mm) gap between the end of the wire and the top
surface of the burner. If not positioned as described, re-position the electrode
accordingly. Bend wire towards center of burner head and position as described
above. If stove is wet, igniter may fail to spark. If igniter fails to spark, use matches
or a lighter, following instructions detailed in OPERATING INSTRUCTIONS –
Lighting the Burners. See your dealer or contact Jetboil for service if igniter fails
to spark for any other reason. 3. If an issue cannot be corrected using these
instructions, see Limited Warranty on back page.
Use care when removing lid. Steam and/or
contents may be hot and can cause injury.
After Use:
1. Turn off control valve (8.1) (tighten clockwise) to
8