Storage After Use; Maintenance; Troubleshooting - Jetboil ZIP Manual Del Usuario

After Use:
1. Turn off control valve (8.1) (tighten clockwise) to extinguish flame. 2. Remove pot
from burner base – hold pot by cozy (10.1), and base by shroud (10.2).
Exposed metal parts will be hot and may cause injury if touched.
WARNING
3. Always disconnect fuel canister after use. Unscrew fuel canister from burner base
(Fig 4), and replace plastic fuel cap.
Always check that the burner is extinguished before disconnecting the fuel
WARNING
canister. Vapors can ignite and cause serious injury.
Packing:
1. Allow stove to fully cool before packing. 2. Place bottom cover (7.1) on pot (7.2).
3. Remove stabilizer from canister and fold for storage (1.2). 4. If using the pot
support: Remove pot support from burner base (Fig 12), and fold legs (1.4). 5. Refer to
Fig 1 for packing contents into pot.

Storage After Use:

1. Always disconnect fuel canister before storing the stove. 2. Ensure stove and pot
are clean and dry before storing. 3. Store the stove in a cool, dry location, indoors.

Maintenance:

1. Flame Check (Every use): The height of the flame should increase from low to
high with counter-clockwise rotation of the control valve. Flame should be blue with
no yellow tipping at full output. Flame should not flash back into burner or lift off of
burner top. If flame abnormalities are found, see your dealer or contact Jetboil for
service. 2. Cleaning Pot (before storage, or as needed): Allow pot to cool before
cleaning. Do not use a dishwasher or abrasive compounds (sand, salt, etc.) to clean.
Only wash by hand with soapy water.

Troubleshooting:

1. Flame does not extinguish: Tighten valve as much as possible, blow out flame, and
immediately detach fuel source. See your dealer or contact Jetboil for service.
2. If an issue cannot be corrected using these instructions, see Limited Warranty on
back page.
8