sunjoe LJSS100 Manual página 4

Support Stand Assembly
NOTE: Due to the weight of the log splitter, we
highly recommend assembling the unit with the
help of at least one other person.
1. Fix the beam, front post and the two
brackets together using four sets of bolts,
washers and lock nuts (Fig. 4).
Lock
nut
Bracket
2. Slide the other end of the beam through the
support stand axle, then loosely thread the
screw knob into the nut (Fig. 5).
NOTE: Do not tighten down the screw
knob yet.
Fig. 5
Support
stand axle
3. Slide the wheels onto the support stand
axle and secure them in place using the
retaining rings (Fig. 6).
Fig. 6
Retaining
ring
Retaining
ring pliers
Fig. 4
Washer Bolt
Screw knob
Beam
Support
stand axle
Wheel
4. Snap the hub caps back onto the wheels.
5. Install both rear posts onto the log splitter
axle through the bottom holes (Fig. 7).
Fig. 7
6. Insert the other end of both rear posts
through the vertical box sections on the
support stand axle. Tighten using the two
remaining screw knobs (Fig. 8).
Fig. 8
Support stand axle
7. Pivot the log splitter so that the front stand
mount rests on top of the front post. Fix
them together using the nuts and bolts
disassembled from the front stand (Fig. 9).
NOTE: The front post may need to shift
forwards or backwards in order to match
the bottom of the front stand mount. This is
why the middle screw knob should only be
threaded on loosely.
Fig. 9
Front stand
mount
4
Log splitter axle
Rear posts
Rear
posts
Screw
knob
Nut
Front
post
Bolt
Bolt