Installing The Shoulder Strap - Chapin Pro Serie Manual De Uso Y Cuidado

SPRAYER COMPONENTS & USE INFORMATION, Continued
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft
(A). To install the pump handle place the handle (C) over the shaft
(A) aligning the pump handle holes and shaft holes. Slide the bolts
(B) through the aligned holes as shown in figure 3. Tighten nuts
(D) to bolts. There are holes in the pump handle to allow for either
left (fig.2-4) or right (fig.5) hand mounting.
Nylon Lock Nut
Threaded Bolt
Figure 1
Figure 4
Tighten nut to bolt

INSTALLING THE SHOULDER STRAP

The top of both the shoulder straps and back pad straps are
attached to the top of the tank and are removable (figure 1). The
back pad strap attaches to the bottom of the tank (figure 2). The
back pad is attached to its strap with velcro and is removable (figure
3). Attach the lower end of the straps by clipping the strap hooks to
the metal frame between where the frame exits the tank and curves
around. (figure 4).
Figure 2
Back Pad strap attachment
Pump
Handle
Pump
Shaft
Figure 2
Line up holes
Figure 5
Right Hand
Back Pad
Strap
Velcro
Attachment
Figure 3
Removable Back Pad
3E
A. Pump Shaft
D. Nuts
C. Pump Handle
Figure 3
Slide bolts through holes
Completed Assembly
Figure 1
Strap Assembly
Removable
Back Pad
Figure 4
Strap Attachment
B. Bolts
Shoulder
Strap
Back Pad