Restoring The Factory Settings - StetSom SX2 Manual De Usuario

Programming
1
5
Programming
The central RX2 lets you mix Memory functions with Learning Mode, it is
possible to carry a device memory by Direct Mode and change some keys
without the other being affected. The process is simple:
1. Follow the steps in the Direct Mode to load into memory the desired
device from the table.
2. Follow the steps in the Learning Mode to program keys/functions desired.
Note: Whenever using the Learning Mode, the buttons/keys that have not
be reassigned will continue executing their original functions.

Restoring the Factory Settings:

Pressing the RESET button (20) for 5 seconds, the indicator light (16) will
flash and the factory setting are restored. The timing will be maintained.
10
2
3
4
Using a single TX2 controller to control
multiple devices at the same time:
For the same TX2 control to command various equipment it must be
synchronized with the central RX2 of each one, to so follow the instructions
in "Synchronizing your Alcance Control" (Page 18). Each car must to have
its central RX2 programmed according to your CD/MP3-Player, to do this,
follow the instructions showed in the "Programming" (Page 20).
Diagnostics
• Low battery indication:
When you release the Control TX2 button, the transmission LED indicator
control TX2 transmission (1) and the central LED indicator (16) will remain
lit for 1 second. Replacing the battery with a new one, CR2032 model is
recommended because you may lose control transmission efficiency.
The TX2 transmitter has a system that is self-off if any key be pressed for
more than 10 seconds to avoid undue battery drain. When you release the
button, the system works normally.
Replacing the battery of the transmitter TX2:
Remove the holster , loosen the two screws on the back , remove the circuit
board from the plastic box, move the discharged removing it from the clip
and put a new battery in place . Observe the battery polarity; the Clip is the
POSITIVE terminal. Mount the control following the steps backwards.
• Loss of synchronization:
The loss of synchronization occurs when keys are pressed TX2 control over
250 times out of the reach of central RX2.
11