16901805EFSM2 P.qxd
Operating INSTRUCTIONS
1. Carefully unpack your Air Purifier.
2. Plug into a 120V AC electrical outlet.
3. Press the power button (
4. You can then select the desired speed
5. To release negative ions into the
6. For optimum air filtration, it is
For continuous use, it's recommended to
operate the air purifier at the MEDIUM
setting. For quieter operation or use in a
bedroom, select the LOW setting. When
high levels of air pollution are present,
select the HIGH setting to quickly
circulate and filter the room air.
Oscillation
The air purifier model is equipped with
oscillation. To start and stop oscillation of
the air purifier, push the button identified
as Oscillation (
panel.
E4
Get user manuals:
See SafeManuals.com
2/2/05
2:00 PM
Page 7
IF FILTERS ARE ENCLOSED IN
A
PLASTIC BAGS PLEASE ENSURE
THAT THE BAGS ARE REMOVED
PRIOR TO OPERATION.
Select a firm level place where there
are no obstructions to the air inlet or
filtered air outlet. A good location in a
room is approximately 1 foot away
from the wall, in a central location of
your home.
DO NOT POINT AIR OUTLET TOWARDS
J
WALL.
). The
unit will turn onto high and the power
light will illuminate letting you know
the power is on.
setting. This air purifier has three
speed settings. You can select from
HIGH (
), MEDIUM (
), or
LOW (
) by pushing the desired
operating speed button on the control
panel.
A. POWER INDICATOR
filtered air, press the ionizer button
B. SPEED CONTROL
(
) to ON and the light will
C. OSCILLATION BUTTON
illuminate.
D. IONIZER CONTROL
E. FILTER SERVICE LIGHT
recommended to operate the air
F. IONIZER LIGHT
purifier continuously. Its rugged motor
G. WASHABLE FOAM PRE-FILTER
has been designed to give many years
H. INLET GRILL
of use.
I. PERMATECH™ FILTER
J. FILTERED AIR OUTLET
CLEANING/MAINTENANCE
INSTRUCTIONS
Turn off and unplug the unit before
cleaning.
1. The outside of the air purifier can be
cleaned with a soft, damp cloth.
2. The rear air inlet grill can be removed
and washed in warm soapy water (not
dishwasher safe). Dry completely
before replacing in the unit.
) on the control
3. The front air outlet grill can be
cleaned of dust with a small soft brush
or cloth.
INSTRUCCIONES DE LIMPIEZA Y
C D
E
F
B
MANTENIMIENTO
Antes de limpiar la unidad, apáguela y
desenchúfela del tomacorriente.
1. El exterior del purificador de aire
puede limpiarse con un paño suave
húmedo.
2. La rejilla posterior puede sacarse y
lavarse con agua tibia jabonosa (no es
segura para el lavavajillas). Séquela
completamente antes de reinstalarla en
la unidad.
G
3. El polvo de la rejilla de salida de aire
puede limpiarse con una escobilla
H
blanda pequeña.
ADVERTENCIA: No permita que la
humedad entre en contacto con el casco
principal del purificador de aire.
INSTRUCCIONES DE LIMPIEZA
PARA LOS FILTROS PERMAtech™
1. ndicador de servicio al filtro (
I
purificador de aire tiene una luz que
se enciende para indicar que los filtros
PERMAtech™ necesitan limpiarse.
2. Revise las condiciones de los filtros
cada dos semanas.
3. Apague la unidad y desenchúfela.
Saque la rejilla agarrándola con los
dedos por las pestañas a ambos lados y
tire hacia usted.
4. Saque el prefiltro de espuma y
examínelo. Si se ve una acumulación
de polvo o pelusa, saque el prefiltro de
la rejilla, lávelo con agua jabonosa,
enjuáguelo y séquelo completamente
por al aire antes de volverlo a instalar
en la rejilla.
5. Antes de reinstalar la rejilla posterior,
inspeccione la condición de los filtros
PERMAtech
TM
, si estuviesen sucios,
sáquelos agarrándolos de ambos lados
y tirando hacia afuera.
6. Para limpiar los filtros PERMAtech™,
use el accesorio para rendijas o una
escobilla de la aspiradora pasándolo
por el lado de la salida del filtro y
tratando de limpiar entre los pliegues
(Figura 1).
Figura 1
NO USE AGUA, DETERGENTES NI
LIMPIADORES DOMÉSTICOS DE TIPO
ALGUNO PARA LIMPIAR EL FILTRO
PERMATECH™.
7. Este modelo tiene pestañas colgadoras
y clips para asegurar el filtro en el
lugar correcto. Antes de reinstalar el
filtro PERMAtech™, cerciórese que la
pestaña colgadora esté segura en
posición. El clip sólo puede instalarse
en el filtro en una posición y debe
poderse deslizar en la pestaña
colgadora del filtro con una pequeña
presión. NO use fuerza para instalar el
clip en el filtro. (Figura 2).
) : El
Figura 2
8. Alinee el clip en la parte superior del
filtro PERMAtech™ con los rieles
dentro del purificador de aire y deslice
el filtro suavemente en el riel (Figura 3).
Figura 3
NOTA: El lado con la empaquetadura
blanda debe mirar hacia adentro.
9. Reinstale la rejilla firmemente en la
entrada de aire de la unidad.
S5