Uniteck UNIFIX 300.1 C Manual De Instrucciones página 23

UNIFIX 300.1C – FIXING
For a use on a roof that is not perfectly flat (e.g. Volkswagen T5/T6), use stabilizer pads : pre-place stabilizers
and tighten them after glue is dry.
N°31 N°32
M6x50 Protection
X8 pad M6
X8
• Fixing by glue (not included): apply glue on the surfaces previsouly prepared (dry and without grease)
that will be in contact with the vehicle roof (see grey areas on the below drawing).
Recommmended glue : SIKA 552. A 300mL tube is generally sufficient.
Recommendations : Apply glue in lines. Avoid closed shapes that prevent air from flowing and slow
down polymerization:
If the gluing
surface is not
sufficient
compared to
the glue and to
gluing areas, it
is possible to
reforce the
fixing by adding
self-drilling
screws and
bolting.
N°33 N°20
Thin nut M6 D6
X16
X16
www.uniteck.fr
Gluing areas in grey
EN
Roof
23