End Of Cooking - Whirlpool OAKZ9 379 H IX Guía De Referencia

5. END OF COOKING

An audible signal will sound and the display will
indicate that cooking is complete.
Press to continue cooking in manual mode (without
a programmed cooking time) or turn the adjustment
knob to extend the cooking time by setting a new
duration. In both cases, the temperature or the grill
level settings will be retained.
BROWNING
Some functions of the oven enable you to brown the
surface of the food by activating the grill once cooking
is complete.
When the display shows the relevant message, if
required press to start a five-minute browning cycle.
Once the browning function has been activated, you
can change the time for which it will run by turning the
adjustment knob. You can also stop the function at any
time by turning the selection knob to select a different
function or by turning it to
.
TIMER
When the oven is switched off, the display can be used
as a timer. To activate this function, make sure that the
oven is switched off and turn the adjustment knob: The
icon will flash on the display.
Turn the adjustment knob to set the length of time you
require and then press
audible signal will sound and the display will indicate
once the timer has finished counting down the selected
time.
Please note: The timer does not activate any of the cooking
cycles. Use the adjustment knob to change the time set on
the timer; press to switch the timer off at any time.
6
to switch the oven off.
again to activate the timer. An
.
KEY LOCK
To lock the keypad, press and hold
same time for at least five seconds.
Do this again to unlock the keypad.
Please note: This function can also be activated during
cooking. For safety reasons, the oven can be switched off at
any time by turning the selection knob to
. STARCLEAN
Before activating this function, pour 200ml of drinking
water on to the bottom of the oven and shut the door.
Turn the selection knob to select the "STARCLEAN"
function and press to
Press to set the end time of the cleaning cycle or to
activate the function.
A countdown will indicate the status of the cycle in
progress.
To prevent steam from coming out and thus
jeopardizing the final results, it is recommended not to
open the door during the cleaning cycle.
Once finished, wait for the oven to cool down and then
finish cleaning by drying the surfaces with a sponge or
a soft cloth.
Please note: like with the other manual functions, it is also
possible to set the end time for the self-cleaning cycle.
and at the
.
confirm.
EN