OdOr fade Warning
Warning
asphyxiation Hazard
not be obstructed.
heater being used.
manual, heater dataplate, or contact the factory
to determine combustion air ventilation
improper combustion.
can include headaches, dizziness and difficulty
in breathing.
specifically for detection of fuel gas leaks.
if a gas leak occurs you should be able to smell the fuel
operate any electrical switches. Do not pull any power supply
of flame. Do not use your telephone.
immediately.
or the main fuel supply valve located at the meter if you use
natural gas.
areas. When you have reason to suspect a propane leak, keep
out of all low areas.
safe by the firefighters and your fuel gas supplier.
check for escaped gas. Have them air out the building and
area before you return. Properly trained service people must
repair any leaks, check for further leakages, and then relight
the appliance for you.
OdOr fading - nO OdOr detected
natural gas. you must determine if you can smell the odorant
in these fuel gases.
to give you a scratch and sniff pamphlet. use it to become
familiar with the fuel gas odor.
Mr. Heater | Gas-Fired Infra-Red Tank Top Heater
odor for a period of time can affect your sensitivity to that
particular odor. odors present in animal confinement buildings
can mask fuel gas odor.
colorless and the intensity of its odor can fade under
some circumstances.
the soil can filter the odorant.
odor at lower levels.
continue to detect any gas odor, no matter how small, treat
it as a serious leak. immediately go into action as discussed
previously.
of the heater, AlWAyS be consciously aware of the odors of
service or repairs, or make any adjustments to the heater on
joints; i.e. hose, connections, etc., is a good safety practice
under any conditions. if you smell even a small amount of gas,
WAit!
a. the MH15t and the MH30t are high pressure propane
appliances and are designed to be connected to a bulk
propane tank.
Valve. the gas flow will automatically stop if the heater fails to
operate for any reason.
c.
D. these heaters are for temporary heating of buildings under
construction, alterations, or repair.
Model
MH15T
BTU
Input
Valve Position
Hi
15,000
Med
12,000
Lo
10,000
Figure 3.
Actual BTU/HR input rate and fuel consumption times for this
appliance may vary.
e-4
if you
MH30T
Hours
BTU Input
Hours
w/20lb.
w/ 20lb.
Tank
Tank
28
30,000
14
36
24,000
18
43
10,000
43