Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Features
Rear Panel
2
1
1.
AC In: Use the included power adapter to connect the mixer to a power outlet. While the
power is switched off, plug the power supply into the mixer first, then plug the power
supply into a power outlet.
2.
Power Switch: Turns the mixer on and off. Turn on the mixer after all input devices have
been connected and before you turn on amplifiers. Turn off amplifiers before you turn off
the mixer.
3.
Line Inputs (RCA): Use standard RCA cables to connect line-level devices, such as CD
players, samplers, or audio interfaces to these inputs.
4.
Phono Inputs (RCA): Use standard RCA cables to connect your line and phono-level
audio sources to these inputs.
5.
Aux Line / Phono Switch: Flip this switch to the appropriate position, depending on the
device connected to the Phono inputs. If you are using phono-level turntables, set this
switch to "Phono" to provide the additional amplification needed for phono-level signals.
If you are using a line-level device, such as a CD player or sampler, set this switch to
"Aux Line."
6.
Grounding Terminal: If you experience a low "hum" or "buzz", this could mean that your
turntables are not grounded. If you are using phono-level turntables with a grounding
wire, connect the grounding wire to this terminal.
Note: Some turntables have a grounding wire built into the RCA connection and,
therefore, nothing needs to be connected to the grounding terminal.
7.
Mic Input: Connect a 1/4" (6.35 mm) microphone to this input. Microphone controls are
located on the top panel.
8.
Master Output (RCA): Use standard RCA cables to connect this output to a speaker or
amplifier system. The level of this output is controlled by the Master Volume knob on the
top panel.
9.
Record Output (RCA): Use standard RCA cables to connect this output to a recording
device, such as a CD recorder or tape deck. The level of this output is based upon pre-
master levels.
4
6
8 9
3
5
5
4
3 4
7
Tabla de contenido
