Chapter 3 Installing Software; Driver Installation - Tally Genicom 9050N Guia De Instalacion

Chapter 3 Installing Software

Driver Installation

24
For a printer to be connected using TCP/IP printing, ensure the printer has been
configured for a valid IP address, subnet, and gateway.
If this has been assigned by a DHCP server, ensure there is a reservation for the
printers MAC address, seen on the network Configuration test page against the
reserved IP address in the DHCP servers scope. See your company network
manager if there is any doubt.
If the printer has not obtained an IP address subnet and gateway automatically
refer to "Setting an IP address manually" on page 21.
Ensure the printer is powered on and has been connected to the network.
You must be logged on to the computer as an administrator or equivalent in
order to install the printer drivers.
1 Load the CD into the drive.
2 After it loads select I ACCEPT to the opening screen as shown.
3 Install software for this printer.
Chapter 3
Installing Software
Quick Start Guide