Adjusting The Mitre Angle - VITO PRO-POWER VITIC750 Manual De Instrucciones

EN
ACCESSORIES
The machine comes with the
following accessories:
- 1 pc Dust suction tube;
- 1 pc Parallel guide;
- 1pc wood cutting blade;
- 1pc hex wrench.
BEFORE USE
- Unplug the power cord before
fitting, adjusting or replacing
accessories;
- Check that the mains voltage
corresponds to the rated voltage
the type plate;
- Remove the packaging material
and loose parts from the tools;
- Check the accessories before use.
Only use accessories that fit the
tools and are suitable for the job;
- Never use blades that are bent,
deformed or damaged in any other
way;
- Check before use that the blade
is correctly fitted.
SELECCIÓN DE LA HOJA
CORRECTA
- Use fine-toothed blades
for smooth and precise sawing.
Use small blades for round sawing;
- Try a coarse-toothed blade first;
- If the jigsaw cut is not sufficiently
smooth and precise, try a more
fine-toothed blade;
- Use very fine-toothed blades
for plastic, aluminium and steel;
- In general course-toothed blades
produce more aggressive cutting
but less precision In comparison
with fine-toothed blades;
14
- Always use sharp blades for best
results.
REPLACING SAW BLADE
NOTE: Make sure the tools
is not connected to the mains
before replacing the blade.
- The brace is fitted/removed
without needing a tool.
Check that the blade is straight
when fitting and tightening;
- Set the button (Button for
adjusting oscillation) to adjust the
oscillation in position 3;
- Pull out the blade chuck lock;
- Insert the blade in the holder with
teeth facing forward, and release
the blade lock;
- Pull on the blade to check that
it is properly fitted;
- To remove the blade, pull out the
blade lock and pull out the blade
by hand;
IMPORTANT: Unplug the
power cord before changing
the blade.
Wear safety gloves - risk of
personal injury.
Hold the blade in your hand
when changing it, otherwise
there is a risk of personal
injury when it comes out.
ADJUSTING THE MITRE
ANGLE
Follow the instructions below
to adjust the mitre angle:
- Screw off the hex bolts from the
bottom of the base plate by the
suitable hex wrench.
Remark: The hex wrench has been
provided;
– Pull back the base plate a little;
- Tilt the base plate to the right
or left to the required position
(up to 22,5˚ from the horizontal
plane). And then screw up the hex
bolts by the hex wrench;
STARTING & STOPPING
- STARTING: Press in the power
switch with your fingers and press
in the Lock button with your thumb.
The lock button can be operated
with your left or right hand;
- STOPPING: Press in the Power
switch with your fingers to switch
off the tool.
The lock button releases and the
tool switches off.