Cold Start Of The Engine - FUXTEC FX-WP143 Manual De Instrucciones

Original Bedienungsanleitung FUXTEC FX-WP Serie_de_en_fr_ita_es_rev10
23.

Cold start of the Engine

1. Place the device on a firm and flat surface.
Press the Start/Stop switch.
1
2. Move the choke lever upwards to "COLD START."
3. Press the carburetor pump about 8-10 times (until gasoline flows in the line)
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous, especially fast train will provide a vital spark and start
the engine
4
5. Then set the choke lever to the "WARM START" position
6. Let the engine warm-up for about 10 minutes at idle
NOTE: If the device does not start after repeated attempts, refer to troubleshooting
chapters.
NOTE: Always pull the starter cord straight out. Pulling the starter at an angle will cause
the rope to rub against the eyelet. Pulling the starter at an angle can cause the starter
2
5
32
3