Tabla de contenido
Idiomas disponibles
Idiomas disponibles
app operation
CUSTOM CHARGING-PERIODIC CHARGING
PAGE
There are four parameters that can be set for charging with custom
charging cycle.
1. Cycle start time: Set the time at which to start charging.
2. Cycle repetition time: Set the days of the surrounding cycle to
repeat, and you can select part or all of it.
3. Charging time: The maximum charging time, after which the charging
station will automatically stop charging. Setting to 0 means that the
charging time is not limited, and the maximum value is 48 hours.
The charging duration parameter and the charging power parameter
can be set at the same time, and at least one parameter must be
selected.
4. Charging power: The maximum charging power, beyond which
the charging station will automatically stop charging. Setting it to 0
means that the charging power is not limited, and the maximum value
is 100 degrees. The charging duration parameter and the charging
power parameter can be set at the same time, and one parameter
must be selected at least.
As shown below:
1
2
54
4
3
5
The cycle charging in the custom charging is as shown in the figure
above. Below steps are mainly required, and one step corresponds
to one picture to proceed in sequence.
1. Select the charging time and the charging power.
2. Select the timed hour.
3. Select the timed minute.
4. Select the repetition cycle.
5. Select the button enabled to set. If the setting is successful, there
will be a success prompt.
6. Select the "Prohibit" button to cancel the periodic charging function.
If the cancellation is successful, there will be a success prompt.
6
Tabla de contenido
