TRAPP JK-500 Manual De Instrucciones página 35

To operate with dry products
(grains):
Place the sealing cover (1).
✔
Place the green crop feeder cover (5).
✔
Select a suitable strainer (diameters 0,8 - 3 - 5
✔
- 12 mm). The resulting product depends on
the diameter of the strainer used.
The dry product is placed in the grain funnel
✔
(2), and then forwarded to be processed. The
end product leaves the equipment through
the lower part.
Be careful not to overload the motor.
✔
Regulate the grain input adjuster according to
the equipment's capacity to grind and to the
strainer chosen. The regulation of the grain
input adjuster is done in the following way:
loosen the wing nut (3) located underneath
the grain input adjuster. Once the regulator
(4) is free, pull in case you need a bigger
opening, and push in case you need a smaller
opening. After regulating, tighten the wing
nut (3).
2
3
4
5
6
Operation
7
1
8
To operate with green products
(foliage):
Remove the sealing cover (1).
✔
Remove the green crop feeder cover (5).
✔
Place the flat strainer (6), as the material will ✔
exit through the upper part of the
equipment.
The green products are placed into the
✔
green crop feeder (5), and then forwarded to
be processed. The end product leaves the
equipment through the upper part.
To operate with palm (cacti),
manioc, etc.:
Adjust the directional flap (8) according to
✔
your requirements.
The material should be introduced into the
✔
machine by way of the input funnel (7).
Note: The size of the cut depends on the
type of herd. Check the instructions of
page 30.
Attention!
The equipment should supplied only
✔
via one funnel at a time.
The simultaneous operation will
cause a overload, with a possible
damage to the motor.
Damage may also occur to the motor
✔
because of overload, if an excess of
material in fed into the machine.
33