Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Assembly Instructions for Table-top Console
Tools required: Hex wrench (provided), Phillips screwdriver, mallet, power drill, and 1/8" drill Bit
(not provided).
18. Position the assembled console at the desired location against a wall. In case of uneven floor,
Floor Levelers are provided at the bottom of both Legs (E and F). Simply tilt the unit back and
raise or lower Floor Leveler by hand to correct tilting, as shown above.
NOTE: YOU MUST USE THIS TIPPING RESTRAINT TO ATTACH THIS UNIT TO THE WALL,
TO PREVENT THE UNIT FROM TIPPING, CAUSING ACCIDENTS AND/OR INJURIES.
19. Now, follow the instructions printed on the plastic bag containing the Tipping Restraint
Hardware to attach the tip-over restraint to the Spine and the wall.
20. The console is now ready for use. Be sure to position your Flat Panel TV in the center of the
console.
NOTE: If you choose the Wall Mount configuration,
E
proceed to PAGE
13
TV
E/F
21.
F
Tabla de contenido
