Phormalab AURA AAA01 Manual De Instrucciones página 5

mounting, or also available on the website www.phormalab.it in the download
section.
When mounting the appliance on a wall, it must be positioned at a minimum
distance of 20 cm from the ceiling and 60 cm from the side walls; the height
from the floor may range, but the heater must never be placed at less than 200
cm from the floor. When mounting the appliance on the ceiling it must be
placed at a minimum distance of 60 cm from the side walls. (pic. 2,3,4)
When the AU heater is mounted to its mounting, orient the heater beam to the
area to heat, and finally tightening the skrew and blocking the heater. The
maximum heating efficiency is with a 45° inclination.
When mounting inside a bathroom, always respect the minimum distances
from showers and baths, and ensure compliance with the electric safety
standards. Furthermore, the commands to adjust the appliance and turn it on
and off must not be within reach of the shower or bath.
Correct installation must always be checked by checking that the line
corresponds as shown in figures 5-6-7-8.
Use and cleaning
To switch on and off the heater, use the switcher of the fixed wire where the
heater has been connected.
When using a power regulator (optional), switching on and off the heater and
the power regulations are made using the regulator itself.
From time to time, remove dust from the disk and bulb using a clean brush or a
jet of compressed air, so as to guarantee that AU provides maximum heating
efficiency at all times.
Electrical connections
See pic.1.
Important information on ecocompatible device
In some european union countries this product
does not fall within the requirements of the
national laws implementing directive WEEE, and
in these Countries the product is not subject to
separate disposal operations at the end of its
working life.
This
Directive2002/96/EC.
This appliance bears the symbol of the barred
waste bin. This indicates that, at the end of its
useful life, it must not be disposed of as domestic
waste, but must be taken to a collection centre for
waste electrical and electronic equipment, or
returned to a retailer on purchase of a replacement.
It is the user's responsibility to dispose of this appliance through the
appropriate channels at the end of its useful life. Failure to do so may incur the
penalties established by laws governing waste disposal.
Proper differential collection, and the subsequent recycling, processing and
environmentally compatible disposal of waste equipment avoids unnecessary
damage to the environment and possible related healthrisks, and also
promotes recycling of the materials used in the appliance.
For further information on waste collection and disposal, contact your local
waste disposal service, or the shop from which you purchased the appliance.
Manufacturers and importers fulfil their responsibilities for recycling,
processing and environmentally compatible disposal either directly or by
participating in collective systems.
EN – DIMMER
Brief Introduction
This Bluetooth Dimmer is fixed, remote-controlled control units. The unit is
designed for the AURA heater, the heater can be controlled by Remote control
and Bluetooth.
Important Safety Instructions
When using the Bluetooth Dimmer, basic safety precautions should always be
followed to reduce the risk of fire, electric shock, or injury to persons, etc. Read
all instructions before using this Dimmer.
Make sure the instructions are stored in a safe place for future reference.
Make sure the control Dimmer is together with the manual
REV. 04 – 10/2021
product conforms to
Check if the voltage indicated on the nameplate of the Dimmer corresponds to
the local mains voltage before using the dimmer.
A multiperture outlet may be used when using the Dimmer. The electricity load
rating marked on the outlet must have the enough current-carrying capability
and corresponds to requirements of the power supply companies and the
regional construction. Check if the voltage indicated on the nameplate of the
Dimmer corresponds to the electricity load rating marked on the socket before
using.
Do not cover anything including but not limited to clothes, blankets, pillows,
papers ,etc. to avoid overheating.
Please note that the Dimmer will not be covered with something including but
not limited to curtains, tents, flags, etc. due to the wind or other environmental
influences when under the work.
Do not make the power cord hang on the edge of the table or touch the quite
hot surface.
Contact with the manufacturer or service agent or a suitably qualified person
for maintenance to avoid danger if the power cord is damaged.
In case of improper use, there is a risk of electrical shock and/or fire hazard.
Operation of the appliance must be discontinued and turn off the electricity
immediately. Do not try to repair the appliance by yourself. Please contact with
the service agent or a suitably qualified electrician for maintenance.
Turn off the electricity before maintenance.
Physically and psychologically immature or mentally handicapped (including
children) person or someone who is lack of the use experience or relevant
knowledge shouldn't use the Dimmer unless under adult supervision.
In order to keep children from the danger of the Dimmer, the Dimmer should
be in the place that children do not have access to it. Never leave them
unsupervised with the Dimmer. Consequently, when selecting the location for
your Dimmer, do so in such a way that children do not have access to the
Dimmer.
The Dimmer must only be mounted by an authorized specialist, paying
attention to the relevant regulations of the power supply companies and the
regional construction regulations.
EU
Do not install programs, timers, individual control systems or any other
facilities to make it be able to be opened automatically. There is a potential risk
of fire if the location is wrong.
Remove the plug from the outlet when not in use.
This Dimmer cannot be used in the construction sites.
Operation Instructions
Remove all packaging material (including anti-vibration packaging on the
lamp) and check the Dimmer, supply cord and plug for signs of damage.
Plug-in the power source, then observe, whether during the first 10-15
minutes the Dimmer works trouble-free (factory password is set as
00000000 (8 zeros)
Control Instructions
Water-proof Switch: Control the power supply of the Dimmer;
Reset Button: Reset the control part of the Dimmer;
Download the app "Phormalab" from App Store or Google play from Android
system, to control the product by Smart phone. The factory password for
pairing is set as 00000000 (8 zeros).