Frequently Asked Questions - MAG CHARGER FLASHLIGHT RL1019 Manual Del Propietário

Operation - Getting the most out of Your Mag Charger
Section 5
How To Go From One Function Set To Another
Your Mag Charger® LED flashlight's "standard" setting is Function Set #1. If you
want to keep that setting you don't have to do anything. Function Set #1 will
always be in effect unless it is changed. If you want to choose a different
function set, follow these steps:
1. Unscrew the tail cap, backing it out of the barrel far enough that the flashlight
will not turn on. (Note: This may require the tailcap to be removed from the
barrel entirely).
2. Pause for 2 seconds.
3. Press the switch button
and keep holding it down.
4. While still holding down the
switch button, screw the tail
cap back in until it is tight.
5. Keep holding down the
switch button. Within about
4 seconds the flashlight
will start to blink.
6. The number of blinks indicates the new selected Function Set.
7. To choose a new Function Set, release the switch button after the
corresponding number of blinks (releasing after 1 blink chooses Function Set #1;
releasing after 2 blinks chooses Function Set #2; release after 3 blinks for Function
Set #3, and release after 4 blinks to choose Function Set #4.) Your choice of a
Function Set remains in effect until you change it by repeating the above
process. (See our Demo video at www.maglite.com)
® LED Rechargeable Flashlight System
NOTICE: To avoid deeply discharging the rechargeable NiMH battery,
always turn the flashlight off when the flashlight beam starts to dim. A dim
beam is an indication that the battery needs to be recharged.
Spot-to-Flood Beam
The quick focusing spot-to-flood beam operates with a simple quarter turn
of the flashlight head assembly.

Frequently Asked Questions

Q. How long can I leave the flashlight in the Charging Cradle (on
charge) without using?
A. Indefinitely.
Q. If dust occurs inside my reflector, how do I clean it without damage
to the reflector?
A. Do not touch reflector. Use a camel hair brush lightly or blow with a
compressed air duster as used on computers and electronics. Use the same
care that you would give a precision camera lens.
Q. How do I get a fingerprint off my reflector?
A. Use a camera lens cleaner and a lint-free cloth.
11