Working With The Unit; Control Panel Description - Fromm & Starck STAR ATFE 13 Manual De Instrucciones

slide (P),
•
• tighten (T).
Step 6-A
Method 1 (W1)
XIII. Assemble the cable trays (3).
XIV. Proceed in the following 3 steps:
1. first screw (U1) the bolts (B) into the crossbar (4) with the wrench (F),
without tightening completely,
2. Push one side of the cable tray (3) onto bolts (B) and then push (U2) the
other side of the cable tray onto bolts (B),
3. Finally, tighten (T) the bolts (B) with the Allen key (F).
The cable tray (3) on the support beam (5) is installed in the same way.
Step 6-B
Method 2 (W2)
XV. Assemble the cable trays (3).
XVI. Assembling the cable tray (3) is done in the same way as with method 1 (W1) in
step 6-A.
XVII. The cable tray (3) should be mounted in the middle of the beam joint when the
frame is extended more than 1720 mm.
XVIII. The length of the cross beam should not be longer than the position of the
limit hole determines.

3.3. Working with the unit

Height adjustment:
1. Connect the plug to the power outlet.
2. Adjust the height using the buttons on the control panel.

CONTROL PANEL DESCRIPTION: