Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Free Speed (No Load)
Maximum Working Pressure
Collet Size
Air Inlet
Recommended Hose Size
Air Consumption @ 90 PSI
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate
for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8" I.D.
and fittings should have 1/4" NPT thread.
Operation
Before each use:
G
Drain water from air compressor tank
and
condensation from air lines. See air
compressor's operators manual.
supply before lubricating or
changing grinding abrasive.
G
Lubricate tool, see "Maintenance"
section in this manual.
G
Select the required grinding stone.
NOTE: The tool is equipped with a 1/4"
collet and uses grinding stones with a 1/4" mandrel. To use grinding stones with a 1/8"
mandrel the 1/4" collet must be replaced with the 1/8" collet supplied.
To change grinding stones:
G
Loosen the collet nut, using wrenches supplied.
G
Insert grinding stone into collet and tighten
collet nut. NOTE: The grinding stone's
shank should be within 1/4" from collet nut
to prevent vibration.supplied.
G
Connect tool to air hose of recommended size.
NOTE: The use of a quick connect set makes
connecting easier.
IMPORTANT: The use of air filters and air line
lubricators is recommended.
To use:
G
Turn air compressor on and allow air tank to fill.
G
Set the air compressor's regulator to 90 PSI. This tool operates at a maximum 90
PSI pressure.
SPECIFICATIONS
OPERATION
Disconnect the die
grinder from the air
ASSEMBLY
Collet
Nut
Throttle Safety
Release
5- ENG
20,000 RPM Max.
90 PSI
1/4", 1/8"
1/4" NPT
3/8" I.D.
5.5 SCFM
Throttle Control Lever
Collet Nut
Grinding Stone
Air Inlet
D22713
Tabla de contenido
