Inserting/Replacing The Battery - Flex PD 2G 18.0-EC-HD Instrucciones De Funcionamiento

PD 2G 18.0-EC-HD
Battery
Weight of
battery/kg
Average
battery Life
(depending
on speed, tool
diameter,load
...)/min
Working
-10~40°C
Temperature
Charging
4~40°C
Temperature
Charger CA 10.8/18.0, CA 18.0-LD
Overview (see figure A)
The numbering of the product features refers
to the illustration of the machine on the
graphics page.
1 Trigger switch
For switching on and off and for
accelerating up to maximum rotational
speed
2 Direction preselector switch
3 Speed selector switch
4 Operating mode turning dial
5 Torque setting turning dial
6 Chuck jaws
7 Workplace lamp
8 Handle
9 Turbo function indicator light
10 Insertion slot for battery
11 Turbo function button
12 Auxiliary handle
13 Li-ion battery (2.5 Ah or 5.0 Ah)
14 Release button for battery
15 Power-indicator button
16 Power indicator
17 Belt clip
18 Fastening screw
19 Bit bracket
AP 2.5 AP 5.0
0,42 0,72
5 10
Operating instructions
WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power tool
Unpack the percussion drill driver and check
that here are no missing or damaged parts.
NOTE
The batteries are not fully charged on delivery.
Prior to initial operation, charge the batteries
fully. Refer to the charger operating manual.

Inserting/replacing the battery

■ Press the charged battery13 into the power tool
until it clicks into place (see figure B).
■ To remove, press the release button 14 and pull
out the battery (see figure C).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may short
circuit the contacts; explosion and fire hazard!
Battery state of charge
■ Press the power indicator 15 button to
check the state of power indicator 16.
■ When the lowest level of the power
indicator starts flashing after pressing
power indicator button, the battery must
be recharged.
Removable belt clip and bit clip
■ Remove the battery pack from the tool.
■ Align the hole of the belt clip 17 and bit
bracket 19 with the threaded hole on the
base of the tool (see figure D).
■ Insert the fastening screw 18 and securely
tighten the screw with a screwdriver (not
included).
Strap fixing
■ Strap fixing is provided to attach a wrist
strap (not included) in order to reduce the
chances of dropping your tool. Wrap the
strip around your hand when carrying the
tool (see figure E).
Fitting/removing the auxiliary handle
CAUTION!
Use auxiliary handle if these are supplied with
the power tool. The loss of control may result
15