Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WIFI CONTROL MODULE FOR ROLLER SHUTTERS AND BLINDS
D - USING THE PRODUCT
1 - CALIBRATING THE MODULE
Before using your device, you must calibrate the
motor. To do this, press (1) the three vertical dots,
then (2) calibrate or press the reset button three
times in succession.
1
3 vertical dots
2
Calibrate
Calibration procedure:
- The blind goes to its opening stop point (unless
it is
already there).
- It goes down to its closing stop point.
- And goes back up to its opening stop point.
IMPORTANT: If the blind does not stop completely
when going down, wait until calibration is completed
then, after a few seconds, restart the calibration.
Tip: If you notice that raising and lowering are
inverted during calibration and operating in the
conventional way, press the RESET button briefly to
invert the module' s raising and lowering channels.
Restart calibration.
10
EN
1
2
X3
2 - USING THE AT HOME APP
1
2
1
Opening command
2
Closing command
3
Setting the percentage of closing and opening
The Thomson At Home app allows you to control
several functions with the ACCESS module, such
as (1) opening and (2) closing as well as (3) the
percentage you close your blind.
3 - USING THE PRODUCT WITH GOOGLE
HOME
Google Assistant can help you control your
connected devices.
For example, you can use the following commands:
"OK Google" Open the living room shutters
"OK Google" Close the living room shutters
For more information on device names or creating/
linking a room, please consult Google support.
A word of advice, however. In order to avoid
unwanted commands if you connect several
modules in one area, we recommend that you
avoid using a group name suggested by Google
Home (bedroom, office, living room, etc.) when
naming your command module.
If you have any problem with the Google Home app
or with setting up the device in Google Home, please
contact Google support.
The setting up procedure depends on your
smartphone and requires an Internet connection:
3
Tabla de contenido
