KTM 64112950044 Instrucciones De Montaje página 23

–
Remove the cable tie.
–
Connect the plug of the USB charging socket
ACC2.
Info
The USB charging socket may not be connected to
ACC1. There is a sticker labeled ACC1 and ACC2 on
the cables of the wiring harness.
If necessary, the connector protection must be shorte-
ned.
Info
On models where the connector
sories is present, the USB charging socket
ded) is plugged into it.
502645-01
–
Route connector and cables without tension and secure with
cable ties.
–
Position the cover, threading the headlight plug-in connector
and the USB charging socket with cable through the opening.
–
Hold the turn signal in area
direction of travel, while pressing the cover tight at the same
time.
The cover engages with an audible click.
–
Repeat the operation on the opposite side.
502644-01
–
Mount and tighten screws
Guideline
Screw, cover
–
Mount and tighten screws
Guideline
Screw, cover
–
Mount and tighten left screw
Guideline
Screw, cover
502646-01
2
(included) to
bm
for technical acces-
2
A
and carefully press against the
bk
.
M5 5 Nm (3.7 lbf ft)
9
.
EJOT PT 2 Nm (1.5 lbf ft)
K50x14
bl
.
M5 5 Nm (3.7 lbf ft)
ASSEMBLY 5
(inclu-
9