Zeiss 432610-9060-000 Manual Breve página 9

Power Supply 12V 100W
10 SWITCHING ON SAFELY
Operating elements of the Power Supply (front):
1 ON/OFF switch
2 Dimmer (potentiometer)
3
Pilot lamp for remote control operation
(external)
4 Reflected/transmitted light selector switch
• Turn the Power Supply on by using the ON/OFF
switch (Fig. 3/1).
• Switch on the microscope (see separate
operating manual).
11 HOW TO GET TO THE FIRST PICTURE
• Turn the desired illumination system alternatively on/off using the reflected/transmitted light selector
switch (Fig. 3/4), RL position (reflected light) and TL (transmitted light), respectively.
• Adjust the illumination intensity of the switched-on lamp by turning the dimmer knob (Fig. 3/2) of the
Power Supply.
Switching over between the illumination systems has no effect on the adjusted lamp brightness.
Therefore, the brightness must be readjusted after every switchover, if necessary.
• If the microscope is connected to the Power Supply unit by means of the control cable (Fig. 2/5), the
dimmer of the Power Supply is inactive and the pilot lamp for remote control operation (Extern) is
lighting. In this case, the illumination intensity of the switched-on lamp is adjusted using the dimmer
of the microscope (e.g. adjusting wheel (Fig. 2/4) on the Axio Scope.A1).
12 SWITCHING OFF SAFELY
• Turn the Power Supply off by using the ON/OFF switch (Fig. 3/1).
• Switch off the microscope (see separate operating manual).
09/2017
SWITCHING ON SAFELY
Fig. 3
432610-6044-008
Power Supply (front)
ZEISS
7