Troubleshooting - Powerworks GDC60 Manual Del Operario

EN
Make sure that children cannot come near the
machine.
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
• Disconnect the garden hose from machine.
• Wind the high pressure hose.
• Clean housing and the plastic components with a
moist and soft cloth.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• replace the damaged parts.
• tighten the bolts.
• speak to a person of an approved service
center.
• Store the machine in a dry, isolated and frost-free
area.
7

TROUBLESHOOTING

PROBLEM
The motor does
not start.
WARNING
NOTE
POSSIBLE SOLUTION
CAUSE
The power Set the power
switch is off. switch to the
"ON" ( | ) posi-
tion.
You do not in- Install the battery
stall the battery pack.
pack.
The power Pull the gun trig-
switch is on, but ger.
you do not pull
the gun trigger.
English
PROBLEM
The machine
does not get
high pressure.
The output pres-
sure varies high
and low.
8
POSSIBLE SOLUTION
CAUSE
The diameter of Replace with a
garden hose is 1" (25 mm) or
too small. 5/8" (16 mm)
garden hose.
The garden hose Make sure that
is blocked. the garden hose
is free from
blockage.
The water supply Open the water
is not sufficient. suppy fully.
You do not in- Install the nozzle
stall the nozzle onto the spray
onto the spray wand.
wand.
The water inlet Clean the filter in
filter is blocked. warm water.
The water supply Open water sup-
is not sufficient. py fully. Make
sure the garden
hose is free from
blockage.
The pump ab- 1. Make sure
sorbs air. that the ho-
ses and fit-
tings have no
problem.
2. Turn the ma-
chine off.
3. Pull the gun
trigger until a
stable flow of
water comes
out through
the nozzle.
The water inlet Clean the filter in
filter is clogged. warm water.
The battery pack Charge the bat-
is out of power. tery pack.
The gun, hose or Operate distilled
nozzle are calci- vinegar through
fied. detergent tank.