Electrical Safety; Safety In The Workplace - Royal Catering RC-EG73 Manual De Instrucciones

The terms "device" or "product" are used in the warnings and instructions to refer to <
Electric griddle >.
2.1.
a) The plug must fit the socket. Do not modify the plug in any way. Using original
plugs and matching sockets reduces the risk of electric shock.
b) Avoid touching earthed elements such as pipes, heaters, boilers and
refrigerators. There is an increased risk of electric shock if the earthed device
is exposed to rain, comes into direct contact with a wet surface or is operating
in a damp environment. Water getting into the device increases the risk of
damage to the device and of electric shock.
c) Do not touch the device with wet or damp hands.
d) Use the cable only for its designated use. Never use it to carry the device or to
pull the plug out of a socket. Keep the cable away from heat sources, oil, sharp
edges or moving parts. Damaged or tangled cables increase the risk of electric
shock.
e) If using the device in a damp environment cannot be avoided, a residual
current device (RCD) should be applied. The use of an RCD reduces the risk of
electric shock.
f) Do not use the device if the power cord is damaged or shows obvious signs of
wear. A damaged power cord should be replaced by a qualified electrician or
the manufacturer's service centre.
g) To avoid electric shock, do not immerse the cord, plug or device in water or
other liquids. Do not use the device on wet surfaces.
h) ATTENTION! DANGER TO LIFE! While cleaning, never immerse the device in
water or other liquids.
i) Do not use in very humid environments or in the direct vicinity of water tanks.
j) Prevent the device from getting wet. Risk of electric shock!
2.2.
a) Make sure the workplace is clean and well lit. A messy or poorly lit workplace
may lead to accidents. Try to think ahead, observe what is going on and use
common sense when working with the device.
b) If you discover damage or irregular operation, immediately switch the device
off and report it to a supervisor without delay.
c) If there are any doubts as to the correct operation of the device, contact the
manufacturer's support service.

Electrical safety

Safety in the workplace