English - AGV K1 Guia De Inicio Rapido

English

THIS HELMET'S SHELL IS MADE OF THERMOPLASTIC RESIN
THIS HELMET'S LINER IS MADE OF POLYSTYRENE (EPS)
1) VISOR
1.1) Visor mechanism
Upper catch seating
Teeth on visor mechanism base
Visor lock
Visor lock slider
1.2) Removing/fitting the visor
The non-scratch polycarbonate visor is fitted with catches which click into
the visor mechanism base. The visor tooth interact with the teeth on the
mechanism base to provide stability when the visor is open in different
positions.
Upper catch
Visor tooth
Lower catch
We recommend that you carry out the following tasks with the helmet resting on a level surface.
1
3
10
K1
To remove the visor, raise it to the fully open position
(1). Start on one side of the helmet by pulling the visor
lock slider (2) downwards and detach the catches from
the visor. Repeat on the other side and remove the
visor.
To fit the visor, start on one side of the helmet with
the visor fully raised and insert the upper catch into its
seating on the mechanism base (3). Next, insert the
2
visor lower catch into the visor lock (pulling the slider
downwards may help) (4). Repeat on the other side of
the helmet. Lower the visor and make sure it is working
properly.
N.B. It the visor does not line up properly with the
rubber seal on the helmet, you may need to adjust
or replace the visor mechanism base. In such case,
contact AGV for assistance.
4
1.3) Customised visor opening
1
The tooth mechanism can be replaced and the visor opening customi-
sed.
The 3 mechanisms available have different numbers of different
thickness teeth, depending on the type of use.
- Touring mechanism (fitted as standard). Red. Functions: visor lock in
open or closed position and intermediate visor lock positions.
- Race mechanism (supplied in box). Blue. Functions: visor lock in fully
2
open or fully closed position without intermediate positions.
- Urban mechanism (supplied in box). Green. Functions: visor lock in
open or closed position, intermediate visor lock positions and microo-
pening.
To remove the tooth mechanism, pull it outwards (1). To reinstall or
replace it, position it in its housing and push the mechanism (2) until it
clicks into place.
11