English - AGV K-4 Manual Del Usuario

English

1) VISOR
1
3
8
THIS HELMETS SHELL IS MADE OF FIBER
THIS HELMETS LINER IS MADE OF POLYSTIRENE (EPS)
1.1) Visor Mechanism
upper connection housing
visor stop 1
visor stop 2
movement base teeth
visor stop cursor
1.2) Visor Removal/Installation
The visor is made of non-scratch polycarbon and has connections that fit into the
housings on the movement base. The teeth of the visor interact with the teeth on
the movement base to offer stability while the visor is open in the various positions.
upper connection
lower connection 1
lower connection 2
visor teeth
We recommend that you carry out the following operations while
resting the helmet on a flat surface.
2
4
To remove the visor, rotate it upwards
until it is completely open (1). Starting
from one of the two sides of the helmet,
pull the visor stop cursor down (2) and
extract the hook-up connections of the
visor. Repeat the operation on the other
side and remove the visor.
To install the visor, starting from one side of
the helmet, with the visor completely rai-
sed, insert the upper connection of the vi-
sor into its housing on the movement base
(3). Then insert lower connections 1 and 2
of the visor in the respective visor stop de-
vices (pulling the cursor downwards if ne-
cessary) (4). Repeat the operation on the
other side. Lower the visor and check that
it works properly.
NB If the visor does not fit perfectly to
the profile of the edge of the helmet,
it might be necessary to adjust or re-
place the visor mechanism base. In
this case, contact an AGV service
centre.