Idiomas disponibles
Idiomas disponibles
SETUP
For best results, fully charge controller and power bank prior to first use.
CHARGING CONTROLLER + POWER BANK
• Using a Lightning Cable, connect to the port at the top of the controller, and connect the other end to
any powered USB source.
• When charging, four LEDs will display , indicating the charging level from 25-50-75-100%.
CHARGE LEVEL INDICATOR
Check battery charge level by pressing the battery status button ( ) on the front lower left of the
controller. The LEDs will indicate the current charge level from 25-100% even when the controller is off.
WIRELESS MODE
• If the controller is off, press the Home button ( ) to turn it on (LED will illuminate).
• Press and hold the Bluetooth sync button ( ) on the back of the controller for 2 seconds to enter
pairing mode (LED will flash rapidly).
• Enter the Bluetooth settings on your device and choose the MOGA controller. The pairing LED will turn
solid when connected.
NOTE: A previously paired device will automatically pair to the controller when powered on.
POWERING OFF
Hold the Home button ( ) for 5 seconds to turn the controller off and save battery capacity.
MOGA CLIP
The MOGA Clip is included for use with gaming on your phone. You can use a USB cable with the clip
attached for charging.
1. Slide Controller into MOGA Clip by tipping top edge in first.
2. Push the controller's bottom edge down into the clip until it locks into place.
3. There are two adjustable articulation dials on the MOGA Clip. Rotate dials in opposite directions to
loosen and adjust position. Rotate dials back to tighten after reaching desired viewing angle.
4. To insert phone, push top edge of phone against top of phone grip to expand upward.
5. Push bottom of phone down flat into place as you reach top limit of phone grip. Adjust phone
horizontally as needed to center over controller.
6. Remove clip by pulling front edge forward to release from notch.
INTEGRATED POWER BANK
The controller's built-in Power Bank allows you to charge your phone during gameplay or while the
controller is off.
• Connect the USB-C end of a Lightning Cable to the USB-C port in the top of the controller.
• If you don't have a USB-C-to-Lightning cable, you can use the the included USB-C-to-USB adapter.
• During gameplay, move the Power Bank switch below right thumbstick to the right (on) to start
charging. If you prefer to use battery power to extend controller usage time rather than charge phone,
move switch to the left (off).
• To charge mobile device when controller is not in use, simply connect cable between controller and
device to begin charging (Power Bank Switch must be ON).
ASSIGNING THE ADVANCED GAMING BUTTONS
1. Press the Program Button on the bottom of the controller for 3 seconds. The LED Connection Indicator
will flash, signaling the controller is in Assign Mode.
2. Press one of the following buttons (A/B/X/Y/L1/R1/L2/R2/Left Stick Press/Right Stick Press/D- pad)
to assign. Then press the Advanced Gaming Button (AGR or AGL) that you wish to assign. The LED
connection indicator will stop flashing, signaling the Advanced Gaming Button has been set.
3. Repeat for the remaining Advanced Gaming Button.
Note: Advanced Gaming Button assignments will remain in memory even after disconnected.
RESETTING THE ADVANCED GAMING BUTTONS
1. Hold the Program Button down for 2 seconds. The LED Connection Indicator will slowly flash, signaling
the controller is in Assign Mode.
1. Press the previously assigned Advanced Gaming Button for 5 seconds, and the function will
be cleared.
Note: To take a screenshot press the options button (...) twice. To record video press and hold the
options button (...) for 1 second. To stop recording press and hold the options button (...) for 1 second.
FAQS
For latest FAQs, visit PowerA.com/Support
PROBLEM: My controller will not power on.
SOLUTION: Confirm the controller is fully charged by pressing the battery status button ( ) on front
lower left of controller. Plug in to recharge as needed.
PROBLEM: I do not see MOGA controller listed in mobile devices Bluetooth settings.
SOLUTION: Press and hold the Bluetooth sync button ( ) on back of controller for 2 seconds to enter
pairing mode (LED will flash rapidly).
PROBLEM: The integrated power bank is not functioning.
SOLUTION: Confirm the controller has more than 25% charge and Power Bank button is switched on.
BATTERY WARNING
Don't attempt to replace the rechargeable battery yourself- you may damage the battery, which could cause
overheating, fire, and injury. The Lithium-ion battery in your device should be serviced or recycled by PowerA
or an authorized provider and must be recycled or disposed of separately from household waste.
Dispose of batteries according to your local environment laws and guidelines.
Don't use or leave the product containing recharegeable batteries exposed to very high temperature (e.g. at
strong direct sunlight or in a vehicle in extremely hot weather). Otherwise, it can overheat, catch fire, or the
performance will degenerate, and the service life will be shortened.
Don't use the rechargeable battery item in a location where static electricity is rich, otherwise, the internal
safety devices may be damaged, causing a harmful situation.
In case the electrolyte gets into the eyes due to the leakage of battery, do not rub eyes! Rinse eyes with
clean running water and seek medical attention immediately. Otherwise, it may injure eyes or cause a loss
of sight.
If the battery gives off an odor, generates heat, or in any way appears abnormal during use, recharging
or storage, immediately remove it from battery charger and place it in a contained vessel such as a
metal box.
Be aware discarded batteries may cause fire, do not heat the controller or throw it into fire.
MOTION WARNING
Playing video games can make your muscles, joints, skin or eyes hurt. Follow these instructions to avoid
problems such as tendinitis, carpal tunnel syndrome, skin irritation or eyestrain:
• Avoid excessive play. Take a 10 to 15-minute break every hour, even if you don't think you need it.
Parents should monitor their children for appropriate play.
• If your hands, wrists, arms or eyes become tired or sore while playing, or if you feel symptoms such as
tingling, numbness, burning or stiffness, stop and rest for several hours before playing again.
• If you continue to have any of the above symptoms or other discomfort during or after play, stop
playing and see a doctor.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
