Control Board - ALFA babycare bbrobot Manual De Instrucciones

• CONTROL BOARD: 1 switch (located on the rear) and 3 touch control buttons (located on
the front)
ON/OFF Switch. Located on the rear of the appliance: The 3 pictograms
1
(steam, blend, vacuum sealing) will light up in green (indicating that the 3
functions are ready to be used) If the cooking jug or sterilising basket are
not correctly fitted, the steam and vacuum packaging pictograms will flash
intermittently in green until they are correctly fitted.
2 Steam. When the Steam symbol is pressed, it will light up in blue, indica-
ting that it is ready to cook, heat, sterilise and/or defrost (according to the
amount of water poured). (See water dose table).
3 Blades. This symbol must be held down so that it may function.
Vacuum. Press the vacuum sealing symbol (symbol in blue for 3 sec.).
4
During the vacuum sealing process, the symbol will light up in blue. When
finished automatically the 3 pictograms (touch control buttons) will light up
in green.
If you press the vacuum sealing button again while the pump is in operation,
the process will be cancelled automatically. The system will automatically
switch off for safety reasons if the nozzle is not connected to the container
or the pipe to the vacuum is not replaced within an estimated waiting time
of 30 seconds.
Steam symbol lit up in a flashing red light: The robot is hot (it is re com-
mended not to touch the appliance until the colour changes to green
(2 min.)
When finished you will hear.
When the blade symbol is lit in blue,
automatically stops blending after 10 seconds
After the first cycle the pictograms will flash red, and after 10 seconds
you can press the blade symbol again.
Press down once again if you wish to keep blending (max. 2 consecutive
cycles).
After two cycles, the LED display will show a red light.
When finished automatically the 3 pictograms will light up in green.
EN
Pantone 1805
Pantone 423
is blending. BBrobot
85