Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8. Insert legs into leg frame by depressing pushbutton, sliding
legs over the receptacle and setting to desired height. Make
sure all the legs are set to the same height. (Figure 4)
Adjusting Leg Height
1. Before using the seat, make sure all
legs are set to the same preferred
height.
2. To do so, depress pushbutton and
slide each leg to desired height by
aligning with proper holes and letting
the pushbutton snap into the correct
hole to lock leg in place. (Figure 5)
3. Make sure legs are locked into place
by pushing down and pulling up on
each leg.
CAUTIONS:
1. Inspect all parts for possible damage before assembling. If
there is any damage - DO NOT USE. Contact dealer/carrier for
further instructions.
2. Make sure that the height adjusting pushbuttons fully extend
through the same corresponding hole of each leg extension.
This ensures that the leg extensions are securely locked in
place at an even height.
3. Make sure all screws, nuts and/or bolts are tightened.
4. Make sure the rubber tips are in place on the leg extensions
and not ripped, worn or missing. Replace any missing or
damaged tips.
5. The rubber tips of all four leg extensions MUST touch the floor
simultaneously at all times.
6. NEVER stand on chair.
NOTE: To maintain appearance and promote good hygiene,
clean periodically with mild soap and rinse with warm water
Wipe bath seat dry after each use.
ENTRETIEN
Il est recommandé de visuellement inspecter le siège de bain de
façon régulière pour s'assurer que toutes les pièces et ferrures sont
bien fixées, que les composants sont en bon état de fonctionnement
sans être usés, déchirés, effilochés ou desserrés, et que rien ne
fait obstacle à un fonctionnement normal et sûr. Ne pas utiliser
le produit si toute pièce ou tout mécanisme semble dangereux
ou endommagé. En cas de problèmes, contacter Medline au
1-800-MEDLINE.
Figure 5
G2-101KRX1 G2-101KX1 (PIC-00303)
REVISED: 11/16/20
Tabla de contenido
