Automatic Cleaning; Spot Cleaning - Venga VG RVC 3001 Manual De Instrucciones

HOME CLEANING

AUTOMATIC CLEANING

• The robot will start to zigzag using
the built-in gyroscope.
• After cleaning the open areas, the
robot will enter edge cleaning
mode and will clean along walls
and around furniture legs.
•
Once the robot finishes its cleaning
cycle, it returns to the charging
dock to recharge.
Note: If its battery gets low (below 20%)
before finishing a cleaning cycle, the
robot automatically returns to the
charging dock.
MOP CLEANING
The robot is equipped with a water tank
that enables the robot to mop floors.
1. Attach the cloth and fill the tank
with water.
2. Remove the dust bin.
3. Place back the water tank and start
the robot.
Tip: you can also use the mopping
function as a dry polishing function.
When finished, empty the water tank,
rinse it with clean water and store it dry
or it may become cloggy and smelly.
Check that the 4 water drainage holes
are not blocked and unblock them if
necessary with a small needle.

SPOT CLEANING

When you select spot cleaning, the
robot cleans a defined area by
spiraling outward about 1 meter in
diameter, and back inward.
When you use this mode, the robot
boosts is vacuum power to provide
the best cleaning possible.
To start place your robot on top of the
spot to clean and press "spot
cleaning" on the remote control.
9 VG RVC 3001