Installation Instructions - Electro Depot VALBERG 14S42 D DX AD 929C Instrucciones De Uso

B
Using the appliance

Installation instructions

WARNING : Risk of electric shock
Disconnect the power supply before installing the
dishwasher. Failure to do so could result in death or electric
shock.
WARNING : The installation of pipes and electrical
equipment should be carried out by professionals.
Information on electrical connections
WARNING : For your personal safety:
• Do not use an extension cord or adapter with this appliance.
• Under no circumstances should you cut or remove the
earthed connection from the power cord.
Caution: Risk of overheating, fire and electric shock:
Regarding your installation, follow the technical characteristics of the appliance in the data
sheet attached to the instructions (voltage, frequency, power, required water pressure, etc.)
Use A 20A branch circuit breaker or a 16A fuse on the appliance's dedicated circuit.
The power cable sections should be 2.5 mm² and the differential switch should be 30 mA.
The power point must be have a protective earth connection. If the socket is not adapted or
damaged, replace it and check the electrical installation so that it meets the aforementioned
requirements.
WARNING : Check that the appliance is properly earthed
before using it.
10 EN
B
Using the appliance
Water inlet and outlet
Cold water connection
• Connect the cold water supply hose to a 1.9 cm threaded fitting and ensure that it is tight.
• If the water supply pipes are new or have not been used for a long time, let the water run
to check it is clear.
• This is required to avoid the risk of the water supply being blocked, which could damage
the appliance.
Standard inlet hose
WARNING : A hose connected to a spray tap can burst if it is
installed on the same water pipe as the dishwasher. If your
sink is equipped with one, it is recommended to disconnect
the pipe and block the hole.
How do I disconnect the safety inlet hose?
1. Close the water supply.
2. Unscrew the safety inlet hose from the tap.
Connecting the drain hoses
• Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into
the sink, being careful to avoid bending or pinching the hose.
• The height of the drain pipe should not exceed 1000 mm.
• To avoid backflow, the free end of the hose should not be submerged in water.
11 EN