Front Panel Operation - JBL SYNTHESIS SDR-38 Manual

Front Panel Operation

analog inputs to the left and right front outputs. Switches off any
INPUT
These buttons select the source
connected to the corresponding
input (or internal input).
Unused sources can be prevented
from being selected in the setup
menu by blanking the name in
MENU > Input Config.
DIRECT
Stereo Direct on/off. Provides a direct analog path from the
surround processing modes and shuts down the DSP circuits.
MUTE
Mutes all analog audio outputs
in the currently selected zone.
MENU
Selects the Setup menus.
OK
Used to enter selections
made in the Setup menu.
8
PHONES
This socket accepts headphones
with an impedance rating
between 32Ω and 600Ω, fitted
with a 3.5mm stereo jack plug.
DISPLAY
This switches the display brightness
between off/dim/bright.
MODE
Selects between Stereo and
the available surround modes
for the current source.
Selects between Zone 1
and Zone 2 control.
Selects the information
displayed on the lower left
portion of the front panel.
AUX
Auxiliary line level input.
EN-19
ZONE
POWER/STANDBY LED
INFO
This indicates the status of
the receiver and is blue when
the Receiver is powered on.
Red indicates the unit is in
Standby mode.
Adjusts the analog output
volume in the selected
zone (line out, speakers
and headphones).
Switches the main power
to the Receiver on and off.
Once the unit is switched
off, it should be left for at
least ten seconds before
switching on again.
Remote Control Receiver. This is positioned behind the
display window, on the front panel. Ensure the receiver
is in a clear line of sight from the remote control for
operation. If this is not possible, use a separate sensor
connected to the input on the rear panel.
Z1 IR
EN
VOLUME
POWER