LUND 67456 Manual De Instrucciones página 9

GB
cannot be repaired and must be replaced with a new one that is free of defects if these components are damaged. Replacement
of the power cord and plug must be carried out by an authorised service centre of the manufacturer.
Instructions for the use of the appliance
WARNING! The cooktop surface can be hot after use. Do not touch it, as it may cause severe burns. Allow the cooktop to cool
down.
When preparing dishes which may spread hot food fragments, personal protective equipment should be worn to protect from
burns.
Make sure that the fl oor near the appliance is not slippery. This will prevent slipping, which can cause serious injuries.
Observe the food at all times and prevent it from burning during its preparation. Food left unattended can burn, which can cause
fi re and serious burns.
When preparing dishes, touch the cooktop surface only with utensils made of wood or plastic. The utensils should be able to
withstand the temperature generated by the cooktop. It is forbidden to remove and distribute food using hands.
If any food is left on the cooktop during or after preparation, remove the food remains before preparing another dish. Food remains
can be burned, causing smoke, unpleasant smell, and aff ect the taste of the prepared food. They may also be the cause of fi re.
Use utensils made of wood or plastic able withstand the temperature generated by the cooktop. Do not use sharp or metal uten-
sils. Such utensils can damage the cooktop surface.
If the preparation of a dish requires the use of oil, spread it on the surface of the cooktop with a soft brush. The appliance is not
used for preparing dishes by deep-frying.
APPLIANCE OPERATION
Installation, start-up and operation of the appliance
The appliance must be unpacked and all parts of the packaging completely removed. It is recommended to keep the packaging,
as it can be helpful for further transport and storage of the appliance.
Prepare the appliance according to the instructions specifi ed in the "Product Maintenance" section.
Before starting the appliance, check that the cooking plates are correctly installed. Open the lid and check that the corners of the
plate have been attached using the brackets in the grill housing (II) and the front edges have been latched (II). The plate can only
be disassembled after pulling the latch.
The appliance is activated by means of the temperature adjustment knob. The appliance has two temperature adjustment knobs,
one for each cooking plate. The knobs are located on the side of the handle. Turning the adjustment knob in the direction of the
"+" symbol indicates an increase in temperature. Turning the control knob in the direction of the "-" symbol indicates a reduction
in temperature.
Before connecting the appliance to the power supply, make sure that the knobs are turned as far as they will go in the direction
marked "-".
Plug the power cord plug into the socket. Turn the knob in the direction marked "+", the indicator light will light up and the plate will
heat up to the temperature set using the adjustment knob. When the heating is fi nished, the indicator light will go out.
The appliance has a built-in thermostat, which allows to automatically maintain the set temperature. Each time the plate starts
to heat up, the indicator light lights up. The frequency at which the heater switches on is determined by the set temperature and
the ambient temperature. The higher the set temperature and the lower the ambient temperature, the more often the heater will
be switched on.
The grill has a lid which can be used in three ways. The closed lid allows food to be toasted on both sides - sandwich maker func-
tion. The lid is attached to the handle by means of a lathe, which allows the height of the lid to be adjusted to the prepared food (III).
The lid lathe makes it possible to set it permanently at a certain height - oven function. Open the lid at a right angle, then pull it
up (IV) and lower it so that the lid guide rests on the lathe projection. The lid is positioned parallel to the bottom cooking plate at
a distance of a few centimetres (V).
The lid lathe allows it to be unfolded completely - grill function. Open the lid at a right angle, then pull it up and continue unfolding.
Both cooking plates should be in the same plane (VI).
Regardless of how the lid is used, both cooking plates can be heated up independently of each other.
WARNING! Special care should be taken when opening the heated lid. Use gloves to protect against high temperatures, grasp
the lid only by the handle.
The cooktop heats up to a high temperature, contact with unprotected body can lead to serious burns. When preparing food, care
should be taken not to touch the cooktop, and the cooked food should checked using appropriate utensils, e.g. pliers or paddles
made of plastic or wood.
When selecting utensils, it is important to take into account whether they can withstand the temperature generated by the cooktop.
Do not use metal utensils or utensils with sharp edges. Such utensils can damage the cooktop surface.
Appliance maintenance
CAUTION! All maintenance must be carried out with the appliance switched off . To do this, unplug the power cord from the socket.
O R I G I N A L I N S T R U C T I O N S
9