Toparc MT-70 Manual De Instrucciones página 13

SETTING UP
TORCH CONNECTION REQUIREMENTS
The power source must be turned off.
1*
2
*Step 1 is only for EASYFIT torches.
TORCH EQUIPMENT
The torch must be fitted with the correct consumables, chosen according to the application and the set current.
Choosing the incorrect consumable will result in cutting defects, premature wearing of the consumables and could even cause the entire unit to
malfunction. The torch is supplied with a pot of silicone grease to minimise the seal's wear and the seizing of metal parts. It is recommended to apply
this grease regularly.
Consumables
Regularly check the condition of the protective nozzle, the contact tip and the electrode for wear and tear, also check these parts if the cutting speed
is significantly reduced. It is advisable to replace the nozzle's contact tip and the electrode at the same time.
MT & EASYFIT
Torch model Calibrate
20 - 50 A
MT-70
Precision cut
Cutting
MT-125
Calibrate
MT-70
65 - 85 A
Gouging
MT-125
MT / EASYFIT / AT
A
B
B
A
C
Diffuser (x1) Electrode (x5)
037564
067189
037557
037564
70 A
067189
039131
45 A
45 A
039131
65 A
85 A
105 A
039148
125 A
Diffuser (x1) Electrode (x5)
70 A 037557
039131
105 A
039148
125 A
To assemble the handle bundle with an EASYFIT torch, insert
the torch connector (A) into the bundle socket and screw on
part B. Tighten the torch.
Connecting the torch to the power source:
Insert the handle bundle connector (A) into the power source's
female bundle socket (C) and screw on part B. Tighten the torch.
Contact tip (x5)
short 037571 short
long 067196 long
short 037588 short
long 067202 long
039155 039315
039162
039179
039155
039186
039193
039209
Contact tip (x5)
037564 037595
039261
039155 039278
039285
EN
Nozzle (x1) Pad (x1)
037625 short
067219 long
037601
037625 short
067219 long
039216 039322
039216 039230
039223 039247
Nozzle (x1) Pad (x1)
037601 037632
039216
039254
039223
13